What Tools are Needed to Install Solera Power Awning Replacement Motor

Question

Question:

what type of screwdriver is used to remove the nuts/bolts on the Solara awning cover ?

asked by: Steve C

0

Expert Reply:

We had a customer send us a picture of all of the tools needed to install the Solera replacement motor # LC266149 which I attached a picture of for you to check out. As far as screwdrivers go you'd need to use a Philips head screw driver and a slot screwdriver.

expert reply by: Jameson C

0

Tools needed
(click to enlarge)

Answer 1

In regards to troubleshooting your Solera Power Awning, the first thing you'd want to do is check your battery voltage. It should be at least 12 volts. If the voltage is good, check for objections in the arms which could be anything from a…

view full answer...

Answer 2

With Solera awnings you will need to have the awning roller wound a total of fourteen times for proper spring tension. It could be yours was over-wound or maybe the motor is getting weak or your battery isn't in the best shape.

view full answer...

Answer 3

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

Due to the fact that carbon fiber bikes have a more sensitive frame, Thule does recommend using the Thule UpRide #TH599000. Bike rack technology has not changed to make the racks less compatible, but carbon fiber bikes have become increasingly…

view full answer...

Answer 6

The Demco Hijacker Autoslide 21K #DM8550038 weighs approximately 305-lbs. The head of this hitch weighs around 70-lbs and can be removed to help make moving and installing this 5th wheel hitch a little bit easier.

view full answer...

Answer 7

I was able to find the exact replacement amber (1A-S-20A) and red (1A-S-20R) lenses. I did a Google search on kaper2 (or Kaper II), and found replacement lenses. Their replacement lenses are shown as measuring 4 inches long, by 2 inches wide by 3/4…

view full answer...

Answer 8

We offer replacement brake shoes for 10 x 1-1/2- and 10 x 2-1/4-inch electric drum brakes but no longer for the 1-3/4-inch width you reference. Dexter part #bp04-065 you referenced is a set of replacement brake shoes for electric trailer brakes…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with the…

view full answer...

What Tools are Needed to Install Solera Power Awning Replacement Motor

Product Page this Question was Asked From

Continue Researching