Does the Go Power RV Battery Monitor Kit Draw Power From the Battery

Question

Question:

Does this device somehow apply a load to the battery circuit when reporting the state of charge and voltage?

asked by: Joe V

0

Expert Reply:

Yes, the Go Power RV Battery Monitor Kit part # GP44FR does pull power from the battery in which it receives a reading from. That said, the power draw is very small and insignificant therefore won't affect battery life.

expert reply by: Conner L

0

Answer 1

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat #MA00-06200K has a 12v fan in it so it's not recommended for use above a shower because there's a risk of water damaging the vent. If the vent hole is in the bathroom but not over the…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 6

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 7

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 8

Hey Don; good question and no other parts - including any type of adapter plate or mounting plate - is needed to mount the 30 Amp Go Power PWM Solar Charge Controller with Bluetooth #GP76QR. The #GP76QR comes with screws and is ready to be mounted…

view full answer...

Answer 9

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 10

The Go Power Overlander Expansion Kit - 200 Watt Solar Panel item #34282182 has everything you need to connect to your existing Go Power Kit with the exception of extension cables. I have listed the lengths available below: 10' Go Power MC4…

view full answer...

Answer 11

Hi Donald, Yes, a higher amperage charger, like the #GP76QR (30 amp), would be able to provide a faster recharge for your battery bank than a 10 amp controller like the #34280503. When adding in the second battery you'll want to wire it in…

view full answer...

Does the Go Power RV Battery Monitor Kit Draw Power From the Battery

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching