Replacement Master Cylinder For Balcrank Surge Brake Actuator

Question

Question:

I have a Balcrank and I need a replacement master cylinder

asked by: Elijah M

1

Helpful Expert Reply:

The Replacement Master Cylinder # 10614 will fit Balcrank T-6 actuators for drum brakes. You will need to reuse your existing mounting hardware.

expert reply by: Bud M

1

Answer 1

Thank you for the photos. It looks like you've got an older version of the Toledo Actuator - 2-5/16" Bulldog Coupler - 6,000 lbs. #16039, which would make sense since the tag says 16030. The available replacement parts for this…

view full answer...

Answer 2

When greasing or re-packing the bearings with grease, you need to fill every space of the bearing with grease. This can be done either by hand, by using a bearing packer #L70025, or if you plan on servicing multiple trailers, or just want to cut…

view full answer...

Answer 3

To replace your surge brakes there are a few things you'll need to know, the first being if you have drum or disc brakes. You can then choose the correct disc or drum brake assembly; you'll need to know your axle capacity and wheel…

view full answer...

Answer 4

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 5

We have a few different parts for Toledo actuators but not a master cylinder rebuild kit. We have the master cylinder that you referenced, #10614. We also have a replacement shock, #1844-2, a pivot bushing, #1745, and a pivot shaft, #1829. If your…

view full answer...

Answer 6

Yes you can install the Hopkins Insight brake controller in your 2021 Ford Ranger and actually you don't need anything else to do so. Your Ranger doesn't have a connector for brake controller wiring and instead has 4 blunt cut wires that are…

view full answer...

Answer 7

If you are talking about the small opening on the outside and inside of the Orifice Connector #T1209800 then those measure 0.0010" and 0.0865" respectfully. I went out to the warehouse and measured them with the digital caliper. Please note…

view full answer...

Answer 8

The part you are looking for is the Brass Connector for Titan Disc Brake Kit, #T4750300. This is the fitting that threads into the master cylinder that accepts the reverse lockout solenoid on your Titan actuator. I have attached a link to this part…

view full answer...

Answer 9

Look at the side of the master cylinder and you'll be able to tell which type of brakes it is designed for by the number. If you see 23744 stamped into the side of it you have a drum brake model. If you have 25744 stamped in the side it's for…

view full answer...

Answer 10

We do have the Titan master cylinder replacement part #DX66FR which has the number 23744 stamped on the side of it. See attached picture. A lock out solenoid would attach directly to the back of the master cylinder without an adapter. If you are in…

view full answer...