Parts Needed to Add Electric Brakes to Shorelander Trailer with 3500-lbs Axle
Question:
I have a 2011 shorelander trailer with an axle, looking to add electric brakes but all I seem to find is disc hydraulic. I have kit with the proper bearings so hopefully it will work
asked by: Chris F
Expert Reply:
I would need to know which hub and drum you'll be using (since you've already found one that matches your bearings), but from what I was able to base off some previous information on Shorelander trailers we've seen you'll likely want to use the # AKEBRK-35L-SA for your brakes. These are self adjusting 10" electric brakes that will fit on axles up to 3500-lbs capacity. You'll also need brake mounting hardware # BRKH7 to mount the brakes to the brake mounting flange on your spindle.
I also recommend adding a 7 way with a junction box all in one like the # HS381-9000, to give you the 7 way you'll need for electric brakes. If you also need some wire to run, there is 10 gauge wire # 10-1-1 available by the foot and butt connectors with part # DW05745-10.
I've linked some review and installation videos of these parts for you to check out as well.
Products Referenced in This Question
Electric Trailer Brake Assembly - Self-Adjusting - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Self Adjust
- 10 x 2-1/4 Inch Drum
- etrailer
more information >
Mounting Hardware for 7" Brake Assemblies
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Hardware
- 7 Inch
- Redline
more information >
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Wiring
- Hydrastar
more information >
Product Page this Question was Asked From
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Continue Researching
- Q&A: Where are the Bearings for the eTrailer Trailer Hubs Made
- Q&A: Replacement Bearings, Races and Oil Seals for Ranger Tandem Axle Boat Trailer with Cool Oil Hubs
- Q&A: How to Measure a Trailer Hub or Dust Cap to Find the Right Replacement Dust Cap
- Q&A: How to Determine if Trailer has 84 Spindle to Pick Out Replacement
- Q&A: Ranger Trailer Cool Hub Replacement Grease Seal AD2527E
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Replacement EZ Loadr Boat Trailer Bearings
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: How to Measure a Trailer Axle