Installation of Towing Relays for 2018 Nissan Titan XD

Question

Question:

I cant figure out how to remove the factory relays. Any tips on how to pull them? Thanks in advance.

asked by: Jamie T

0

Expert Reply:

The factory relays should just pull out of the fuse box, which will allow you to use the # C57000 to replace them with new towing relays. I've linked a review and installation video that shows the process.

expert reply by: Erik B

0

Answer 1

A trailer light that only has 1 wire means that it grounds through its mounting hardware. The single wire is the power wire. The best surface to ground a light to is steel. If steel is not available in the area the light installs you can attach a…

view full answer...

Answer 2

The brown relay is the correct one for activating the 12 volt accessory circuit of a 7-way on your 2017 Nissan Titan. With the part #C57000 you will get this relay as well as two additional blue relays. Most likely replacing the relay is what will…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Installation of Towing Relays for 2018 Nissan Titan XD

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching