Solution for Lippert Ground Control Remote that Won't Take a Charge

Question

Question:

is it possible to replace the battery in the LC358601 remote. mine wont take a charge

asked by: Ken A

1

Helpful Expert Reply:

The battery of the remote # LC358601 is not replaceable. If yours won't take a charge that would indicate it's time for a new one.

expert reply by: Jameson C

1

Answer 1

It is definitely odd that your jack is only doing this some of the time. Before getting too far into it, I highly suggest checking all the grounds as if one went bad, it can cause any number of weird things to happen. If your grounds all look good,…

view full answer...

Answer 2

The Replacement 6-Amp Auto Reset Breaker for Lippert Components Power Stabilizer Jack #LC134181 are designed for use with the Lippert Electric Stabilizer Jacks that have switches such as the Lippert Components High-Speed Power Stabilizer Jack - Black…

view full answer...

Answer 3

I spoke with my contact at Lippert and when I described the problem you are having he said you would need to replace the touch pad with part #LC358601 as yours has gone bad.

view full answer...

Answer 4

The switch should allow power to go through it when the switch is in the "on" position but if it's off and power is going through it that would not be a good sign. But I believe you are asking about it while in the on position. It's…

view full answer...

Answer 5

If the breaker is resetting that means the motor is wanting to draw too much amperage. Since you've replaced the switch already you've narrowed it down to that. For the replacement motor you'd then want the part #LC352338. This is an…

view full answer...

Answer 6

A corroded circuit breaker could certainly account for the sporadic operation of your trailer's powered stabilizer jack. So could loose or corroded wiring or connectors. For a new breaker you can use part #LC134181. This is a 6-amp auto-resetting…

view full answer...

Answer 7

The 6-Amp Auto Reset Breaker for Lippert Power Stabilizer Jack #LC134181 is self-resetting. It automatically will reset itself after the breaker trips. If the circuit continues to draw more amperage than the breaker is rated for it will constantly…

view full answer...

Answer 8

We have actually heard from Lippert about this type of issue and they recommend replacing the 6 amp fuse with a 30 amp fuse. This should resolve the issues you're describing.

view full answer...

Answer 9

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won't extend or retract even with the motor running. It's possible that it may have been over-extended or something internally has been stripped or…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Solution for Lippert Ground Control Remote that Won't Take a Charge

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching