Can Pro Series Square Trailer Jack PS1401010376 be Paired With Another Jack

Question

Question:

Can this jack work in tandem and if so does it take 2 of these sample jacks or is each one a separate part and if so what is the other jack part number?

asked by: Clint P

0

Expert Reply:

The Pro Series Square Jack, # PS1401010376, can work in tandem with another jack but it was not designed to have a mate that has a pin facing out opposite if # PS1401010376. What you can do is use # PS1400990376, which has the pin at the front. You would need to provide your own connection between the two jacks.

expert reply by: Michael H

0

Answer 1

I went out to our warehouse to measure the inner diameter of the inner tube of the Pro Series Square Jack with Footplate #PS1400800383. I found the inner diameter to be 1.7 inches. I have attached a photo showing this measurement for you.

view full answer...

Answer 2

The Pro Series Square Jack - Drop Leg w/ Spring Return, #PS1400950376, that you referenced would work well for your trailer, but you would most likely have to do some fabrication to install this jack on each side at the rear. The outside dimension of…

view full answer...

Answer 3

I have not heard of any complaints from customers about the Pro Series Trailer Jacks. The #PS1400800383 jack features a zinc plated inner tube and the jack is constructed of steel. The Pro Series #PS1400800383 is comparable to the Bulldog Square Jack…

view full answer...

Answer 4

The dimensions for the bottom plate of the Pro Series Square Jack #PS1400990376 are 8-3/4" on the handle side of the plate and 7-7/8" on other side. The outer jack cylinder is 4" square and 24-18" tall. I have included the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Can Pro Series Square Trailer Jack PS1401010376 be Paired With Another Jack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching