Replacement Lid & Operator Mechanism For MaxxFan Plus 4500K Roof Vent

Question

Question:

Thanks Kyle The lift arm looks tweaked also on 1side. Could that b why it will not fully engage In open position? I will order the operator part u suggested if u think that is the issue instead. Do u have a suggestion for the seized set screw to remove fan blade to access parts to replace? Thanks

asked by: Joy W

0

Expert Reply:

Let's go ahead and start with the lift mechanism, which is also called the operator mechanism for your MaxxFan Plus Roof Vent # MA00-04500K, which is faulty and why your fan won't stay open. For that we do offer the replacement:

- Replacement Operator Mechanism # MA10-20281K-1AF

In regards to the replacement lid in Smoke for your MaxxFan Plus vent, we do have that part, which is the following:

- Replacement Lid for MaxxFan and MaxxFan Plus Roof Vents - Smoke # MA10A40009K

expert reply by: Kyle S

0

Joe W.

4/29/2021

Thanks Kyle The lift arm looks tweaked also on 1side. Could that b why it will not fully engage In open position? I will order the operator part u suggested if u think that is the issue instead. Do u have a suggestion for the seized set screw to remove fan blade to access parts to replace? Thanks

Reply

Kyle S.

4/29/2021

If the lift arm itself looks "tweaked" or somehow damaged, then I do recommend replacing that as well: - Replacement Lift Arm for MaxxFan Roof Vents # MA10-20222KS As for the seized screw, there really isn't much we can offer there other than home remedies like holding a screwdriver in place and trying to turn it slowly while hitting the back of the screwdriver with a hammer to create sort of an impact wrench.

Reply

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 8

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

We have actually spoken with Ventline regarding your model AS-13 M-VD0449 in the past and they have confirmed that the correct replacement cover is the part #BVD0449-A03 in Smoke or #BVD0449-A01 in White. The cover measures 14 inches x 14 inches and…

view full answer...

Replacement Lid & Operator Mechanism For MaxxFan Plus 4500K Roof Vent

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching