Replacement Motor Solution for Kwikee Series 32 RV Step Made in 1996

Question

Question:

We have the Kwikee manual. Part number for a new motor is listed as 909502. It seems as though Lippert bought Kwikee after 1996. Which motor do we actually need? I cant find a cross reference to the motor part number 909502.

asked by: Jeff S

0

Expert Reply:

Since your Kwikee 32 series step was made before 1999 you'll need the upgrade kit part # LC379145 to replace the motor and other components needed. This comes with more than just the motor but the motor design has since changed so the upgrade components allow it to convert your step to the current design.

expert reply by: Jameson C

0

Answer 1

I found the correct motor for you but we carry it as a different part number. You'd need the Lippert Components Kwikee Step Motor Replacement Kit For Pre-IMGL #LC379608 and you'd be set.

view full answer...

Answer 2

Yes, the Lippert Components Kwikee Step Motor Conversion/Upgrade Kit #LC379145 is the correct upgrade kit for your step setup as this is a confirmed fit for Series 32 steps like what you have. On the sticker in the picture you submitted you can see…

view full answer...

Answer 3

Given the age of your steps and that you likely still have the original parts which would be Pre-IMGL series, you are going to want to do the complete upgrade kit while you are in there because the original motors are no longer produced. - Motor…

view full answer...

Answer 4

Thanks for all the info you gave on your step setup. We've had similar questions to this before and have spoken with Lippert about what the options are. There is a replacement motor available only for those parts that show number 5973820. If your…

view full answer...

Answer 5

You need the Replacement Motor with Mounting Plate for Kwikee Electric RV Steps #LC379608 for your 1999 Winnebago Brave. This is the motor that has been confirmed to replace your step motor on the Kwikee Series 32 steps.

view full answer...

Answer 6

If you were to use a Thule cargo box like the Motion XT #TH629806 then yes, this box is compatible with a Yakima round bar roof rack. Sometimes the mounting hardware that comes with roof accessories will require an adapter to fit different style of…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The correct replacement for a Kwikee Step Motor 369545 is the Replacement Motor for Kwikee Electric RV Steps part #LC379147.

view full answer...

Answer 12

Since you need the Replacement Control Unit for Kwikee 38 Series Electric RV Steps #LC363989 I'm assuming you have 38 series steps on your 2017 Thor Windsport. The correct replacement motor for these steps would be the #LC379147.

view full answer...

Replacement Motor Solution for Kwikee Series 32 RV Step Made in 1996

Product Page this Question was Asked From

Continue Researching