RV Check Valve for Fresh Water Systems and Remco 55 Aquajet

Question

Question:

will this part fit the subject water pump outlet?

asked by: Alan M

0

Expert Reply:

The RV Check Valve for Fresh Water Systems, # 37262195, has an 1/2" MPT x 1/2" FPT threads. Please verify the thread type on your Remco 55 Aquajet for fitment. Adaptors are available if needed.

expert reply by: Michael R

0

Answer 1

The difference between the Valterra RV Waste Valve #T60, and the Valterra RV Waste Valve #T60A, is that #T60 is a 3" Hub, and #T60A is a 3" Spigot. The difference between a spigot and a hub, is that a spigot is something that is to be…

view full answer...

Answer 2

In the highest speed setting the fan of the Fan-Tastic roof vent part #FV802250 that you referenced will draw 3 amps. 3 amps is 36 watts.

view full answer...

Answer 3

You should be able to tell which Valterra Double RV Waste Valves you need by inspecting your current connection points. The one end with the lugs on it is the same on all 3 parts so you simply need to determine if you need hubs, spigots, or a…

view full answer...

Answer 4

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

view full answer...

Answer 5

If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727 you'll see that the top hook goes much wider than the bottom one. There wouldn't be a frame dimension that this will work with since trailer frames…

view full answer...

Answer 6

Lippert Carpet Protectors for RVs with Slide Outs #LC134993 do not permanently install though you could leave them where you place them if you want. A slide-out generally slides on 2 rails below the floor of the slide-out room. That is where the most…

view full answer...

Answer 7

The Thule UpRide Roof Bike Rack #TH599000 will work perfectly on your existing Thule Square Crossbars. This rack includes mounting hardware that will clamp around square, round, or aero-style crossbars without having to use an integrated T-slot. I…

view full answer...

Answer 8

The direct replacement for your Atwood Gc6aa/10E water heater has been discontinued. I recommend the Atwood RV Water Heater Item #DMC74FR which only requires a 12-3/4" x 12-3/4" cutout. This is a standard gas and electric, 10,000 BTU water…

view full answer...

Answer 9

Yes it is; for a 6-gallon tanked RV water heater, there isn't a better option than the Dometic: - Dometic RV Water Heater - Gas and Electric #DMC74FR At 10,000 Btus, this water heater has a higher heating capacity than other units for better…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Answer 12

As long as you aren't exceeding the speed rating of the tires which would cause them to get to an excessive heat you are fine. Trailer tires are designed to be inflated to their max PSI rating when cold and then the pressure increase from heat…

view full answer...

RV Check Valve for Fresh Water Systems and Remco 55 Aquajet

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching