Which Mounting Brackets for Westin PRO TRAXX on 2021 Ram 1500 BigHorn

Question

Question:

Hello, I have a 2021 Ram 1500 Big Horn Edition. 4wd. I have the Westin 4inch Pro Traxx Oval Nerf Bars. I bent all three mounting brackets on the passenger side. and one of the brackets on the drivers side. The Nerf bars themselves are undamaged. The truck is undamaged. All Nuts and bolts are tight. Just the brackets are bent some. Will this kit provide the brackets I need to Replace?

asked by: John C

0

Expert Reply:

You'll want to use the Replacement Mounting Hardware Kit for Westin PRO TRAXX 4" Nerf Bars - Manufactured After 2017 # 21-2408PK. These are the mounting brackets for the Westin PRO TRAXX # 21-24085 confirmed to fit a 2021 Ram 1500 with a crew cab, like your BigHorn edition.

expert reply by: Erik B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

Hey Mike I checked with Westin and I can confirm that the Westin HDX Xtreme Nerf Bars item #W45XV do indeed fit the 2021 Ram 1500 Quad Cab. The instructions on their website say crew cab as well. This is pretty common amongst aftermarket part…

view full answer...

Answer 10

Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a 2" receiver we do have the B&W #BWRHXA2182 if you need to use your 2" ball mount or hitch mounted…

view full answer...

Answer 11

Hi Jeremy; that's a good question and you'll actually need to go ahead and re-do the set up of your weight distribution system after adding the Timbren Rear Suspension Enhancement System #TDR1500DS to your 2019 Ram 1500. So it wouldn't…

view full answer...

Answer 12

For your 2019 Ram 1500 the Curt TriFlex NEXT Trailer Brake Controller item #C24VV can be installed with a plug and play adapter using the Curt Custom Wiring Adapter item #C51458. The port you need is right above where your right foot would be covered…

view full answer...