Determining The Correct Weight Distribution Hitch For Towing 2016 Gulf Stream Wide Open 310KBS

Question

Question:

Looking at the Blue Ox WD sway control hitch, but need a 2.5inch shank. The trailer TW is about 1200lbs, so that would mean the BXW1503. Reading another persons question, it looks like I can bump up to the BXW2003. How would this work in my situation? Would tow experience be hampered with moving up to the BXW2003? Tow Vehicle is: 2016 GMC Sierra 2500 HD Camper is: 2016 gulf stream wide open 310KBS Thank you

asked by: Matt W

0

Expert Reply:

I would be happy to go over finding the correct weight distribution hitch for towing your 2016 Gulf Stream Wide Open 310KBS with your 2016 GMC Sierra 2500HD, but you will want to confirm the total tongue weight of your setup.

Total tongue weight is the tongue weight of your fully loaded and ready to tow trailer plus the weight of any cargo behind the rear axle of your truck. The easiest way to get an accurate tongue weight measurement is with a tongue weight scale like the # e99044 but there are other methods which are outlined in the included help article.

Now assuming that your total tongue weight is the 1200lbs you mentioned then the Blue Ox SwayPro Weight Distribution w/ Sway Control - Clamp On - Underslung - 15K GTW, 1.5K TW # BXW1503 would be correct if your trailer has an underslung coupler which is pretty uncommon so you would likely need the # BXW1500 which is the same system but designed for a standard coupler.

These systems are rated for total tongue weights ranging from 1000-1500lbs which is likely where you total tongue weight will fall, but you will need 2" hitch ball # A-90 or 2-5/16" hitch ball # 19286 to match the coupler on your trailer.

Since your Sierra has a 2-1/2" receiver you would also need Blue Ox SwayPro Weight Distribution Shank for 2-1/2" Hitches - 9" Long - 9 Hole Adjustment # BXW4028.

The Blue Ox SwayPro Weight Distribution w/ Sway Control - Clamp On - Underslung - 20K GTW, 2K TW # BXW2003 you were looking at is compatible with 1500-2000lbs of total tongue weight, but would require your trailer to have an underslung coupler.

I included videos of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

When it comes to switching out your Reese distribution shank to a bigger one I would recommend going to The Blue Ox SwayPro Weight Distribution Shank for 2-1/2 inch Hitch - 9 inch Long - 9 Hole Adjustment #BXW4028. It is very similar to The Blue Ox…

view full answer...

Answer 2

You are correct, you'll just need a WDS shank that is capable of working with your 2017 Ford F-250 with a 2-1/2" x 2-1/2" trailer hitch receiver. I recommend checking out the: -Blue Ox SwayPro Weight Distribution Shank for 2-1/2"…

view full answer...

Answer 3

The Blue Ox SwayPro Weight Distribution item #BXW1503 weighs 91 lbs. The actual weight of the weight distribution system is not added to the tongue weight of your trailer. A weight distribution system is recommended off of a trailer's tongue…

view full answer...

Answer 4

The correct way to select the right Blue Ox SwayPro Weight Distribution is based on the tongue weight of the loaded trailer plus any gear behind the rear axle in the tow vehicle. The two dot bars part #BXW4006 are rated for up to 750 lbs, the three…

view full answer...

Answer 5

I do have an option for you but suspension enhancements for the tow vehicle won't help much with sway. I instead recommend a weight distribution system with sway control which will take the place of suspension enhancements and if you choose the…

view full answer...

Answer 6

You will need to replace your current Pro Series hitch with the Strait-Line Weight Distribution #RP66075. This will also give you a much better sway control than the Friction Sway #83660 you currently have. The Pro Series does not offer a set of bars…

view full answer...

Answer 7

Air bags like the Firestone Ride-Rite Air Helper Springs #F2609 will not increase the weight on the rear axle. The only thing they are going to do is help level out the truck. The weight will already be on the rear axle in the back of the truck, air…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

You're welcome Chris! Sounds like you've more then got the hitch covered. I can not think of a better option then the TorkLift SuperHitch Magnum Trailer Hitch item #TL74FR. You will be able to pull anything and everything with this hitch and…

view full answer...