Availability of Surface Mount 4" Round Trailer Taillight That Uses 2 Studs On Back To Mount

Question

Question:

Im interested in this light as a direct replacement for my homemade utility trailer that has a metal can that surrounds the light. It would fit into the can with mounting bracket in the back of the can with the ywo mounting bolts. I would like it in LED. Is that possible?

asked by: Dave

1

Helpful Expert Reply:

I have another option for you, but we do not have an LED light that mounts in the same fashion as the Trailer Tail Light - Stop, Turn, Tail - Incandescent - Round - Red Lens # ST24RB so you would not be able to install an LED light in the mount you have on your trailer.

The only option would be to stick with an incandescent light like the # ST24RB. Since they are mounted inside of the can you can use two # ST24RB as you do not need the license plate light.

I included a video of the # ST24RB for you to take a look at.

expert reply by: Samuel C

1

Answer 1

Yes, the Replacement Lens for Optronics #A24RB which is designed as a replacement for the Trailer Tail Light #ST24RB and #ST25RB does snap onto the tail light assembly.

view full answer...

Answer 2

The Round Trailer Tail Light #ST24RB grounds through the mounting studs so the two wires are all that is necessary for activating the stop/tail/turn signals of the light. The bulbs are dual intensity so each wire will control a different intensity of…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Availability of Surface Mount 4" Round Trailer Taillight That Uses 2 Studs On Back To Mount

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching