Extang Trifecta 2.0 Soft Tonneau Cover Replacement Tarp For 2004 Dodge Ram Pickup

Question

Question:

I have a Extang Trifecta signature series bought in 2011. From extang factory outlet. Their item no. is: E18 46775. Cover is canvas on top. Do you have a replacement tarp, if so what item number is it?

asked by: Tom D

0

Expert Reply:

We have the replacement part for the 6-1/2 foot Extang Trifecta 2.0 # EX92770 on a 2004 Dodge Ram Pickup # EX92770-20.

expert reply by: Adam E

0

Answer 1

It will be difficult to match up a replacement tarp for the Extang Trifecta tonneau cover on your 2015 Silverado 1500 6-1/4' bed without a serial number. If you have Extang Trifecta Signature 2.0 Soft Tonneau Cover - Folding CANVAS #EX94450 then…

view full answer...

Answer 2

The correct replacement tarp for the Extang Trifecta 2.0 Soft Tonneau Cover #EX92770 on your short bed 2007 Ram 2500 is found as part #EX92770-20 on our site. The part #EX92450-20 you were looking at is for various 2014-2019 GM short bed pickups.

view full answer...

Answer 3

The Replacement Tarp for Extang Trifecta 2.0 Soft Tonneau Cover EX92635-20 will install following the installation instructions of the #EX92635 you see attached. This is only a fit for the 1994 - 2010 Mazda B Series Pickup 7 Foot Bed and the 1983 -…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 7

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 11

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 12

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Extang Trifecta 2.0 Soft Tonneau Cover Replacement Tarp For 2004 Dodge Ram Pickup

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching