Does Roadmaster Sway Bar for 2016 Jayco Precept Fit with Factory Sway Bar

Question

Question:

I have a 2016 Jayco Precept 31UL. It sways in the wind very badly. I am looking at buying the Road Master RM-1139-149 sway bar. In looking under the coach it appears there is already a sway bar that was factory installed. Could this be true? If so can I install the RM sway bar in addition and minimize the sway? The current set up has a product number of 8728 but there are no other numbers or manufacturer info.

asked by: Greg J

1

Helpful Expert Reply:

For your 2016 Jayco Precept motorhome the Roadmaster sway bar part # RM-1139-149 does fit with the factory sway bar you have now so you'd basically have two sway bars installed for a much more improved ride quality.

expert reply by: Jameson C

1

Answer 1

For a steering stabilizer that fits your 2018 Fleetwood Bounder 36D on a Ford F-53 chassis, I verified with the manufacturer the correct fit, which is the following part number: - Roadmaster Reflex Steering Stabilizer #RM42RR You made a really nice…

view full answer...

Answer 2

The biggest improvement in ride quality and sway you can get from your 2019 Tiffin 32SA would be with a rear sway bar like the part #RM-1139-149 which is a confirmed fit for your motorhome. That would be the best bang for your buck you can get and…

view full answer...

Answer 3

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

A drop axle certainly can make it tough to reach the star wheel adjuster on a drum brake. The adjuster spoon tool we offer #W80630 has a 90-degree bend that will often let you get access to the adjuster even on a drop axle. Essentially you will need…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Does Roadmaster Sway Bar for 2016 Jayco Precept Fit with Factory Sway Bar

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching