Replacement Dust Cap For Americana Trailer Wheel Center Cap # AM90175

Question

Question:

Hello Is it possible to buy the plastic center dust cap separate from the metal hub cap shown here AM90175 Thanks

asked by: Craig E

0

Expert Reply:

It sure is!

The replacement cap plug for the Americana Trailer Wheel Center Cap - Stainless Steel - 3.19" Pilot # AM90175 is the Trailer Wheel Center Cap Plug in Black # AM90081, or Chrome # CCP-60C.

I included videos for each of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

We do have a snap in plug for Lionshead trailer wheel center caps. The Snap-In Plug for Lionshead Trailer Wheel Center Caps - Chrome #LHSI60C will fit the following three models. #LHCS102, #LHCS108, #LHCS109. If you have one of these models then…

view full answer...

Answer 2

If the center cap of your rim is 1-7/8 inch in diameter the #AM90081 that you referenced will fit it and work well. That's pretty small though so I would be surprised if it worked for you application since it's used as a center for a…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 4

Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs #LG-217884 only will use one switch. If you were to use two motors, then dual switches would be used. I've attached a diagram to assist. The input wires from the battery can…

view full answer...

Answer 5

We've got you covered! To replace your wheel bolts you need the Dexter Wheel Bolt #7-262 which is a 1/2" diameter and 2-11/16" long. Since your hub and drum assembly looks to be pretty worn though I recommend just replacing…

view full answer...

Answer 6

I recommend replacing your wheel center caps with the Lionshead Trailer Wheel Center Cap w/ Snap-In Plug #LHCS109-SI60C as the largest replacement plug I can find is the Plug #CCP-60C which only has an outside diameter of 2-3/16". The new…

view full answer...

Answer 7

I believe you're looking for the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459. This is the same thing you're referencing in your question, measures 12" diameter x 2" wide, and fits 6,000 lb axles with…

view full answer...

Answer 8

The Dexter brake assembly set part #23-112-113 is for a 6k axle so the correct hub drum would be the part #K08-201-9B for a non-pre-greased hub that matches what you need.

view full answer...

Answer 9

You shouldn't really have any play with the Easy Grease Trailer Hub and Drum Assembly #AKHD-655-6-EZ-K. If you are getting play in it then the bearings most likely are either not set correctly or were the incorrect choice for your…

view full answer...

Answer 10

Yes, all of the hub/drum and brake assembly components of a Lippert 5,200 lb axle are exact same as Dexter 5,200 lb axle. This includes the hub/drum part #AKHD-655-6-EZ-K that you referenced as well as matching assemblies part #AKEBRK-6.

view full answer...

Replacement Dust Cap For Americana Trailer Wheel Center Cap # AM90175

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching