Will the 2-Wire RV Propane Gas and Carbon Monoxide Detector Work for Butane

Question

Question:

I want to use this on a boat and I have a one burner butane stove like they use at an omelet station. I wondered if it would detect butane fumes? Also, do you know how many amps or watts this draws?

asked by: Dean B

0

Expert Reply:

The 2-Wire RV Propane Gas and Carbon Monoxide Detector part # RS54FR is not designed for butane but I spoke with the manufacturer and they said if the levels are high enough it will detect this and signal an alarm. The power draw is minimal, 17mA.

expert reply by: Conner L

0

Answer 1

Typically the life span of the carbon monoxide detectors doesn't start until the first power up. So they are most likely still good. We also carry detectors for gas and carbon monoxide should they no longer have any. RV Propane Gas and Carbon…

view full answer...

Answer 2

This has happened a few times before with the 2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - Black #RS54FR, where someone replaces their old non-functioning alarm with a new one, but the new alarm appears not to work when the RV is…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Answer 5

Atwood is no longer in business so you'd have to switch over to a new brand in order to get what you need. We currently only carry the RV Propane Gas #RS44FR (white #RS64FR) which comes with two different trims (large: 7-1/4" long x…

view full answer...

Answer 6

I recommend the #RS34FR to replace your current LP gas detector. This is a simple 2 wire design making for easy installation.

view full answer...

Answer 7

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 8

Based on what you are saying, it sounds like the detector is faulty and needs to be replaced; you did the right thing with vacuuming it and checking the batteries, as those are the two steps that need to be taken to ensure there isn't a…

view full answer...

Answer 9

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 10

Hey Dave, for a 60 amp charger the 6-gauge wire that you have currently is not going to cut it. You will want to use 4-gauge copper wire for your 15' run when using the Progressive Dynamics PD9200 Series Battery Converter Charger #PD9260C. For a…

view full answer...

Answer 11

The Atwood 31013 is no longer made. The best choice for replacement is the RVCO #RS34FR which mounts flush against the wall, and the overall measurements are 4-1/4" square, and it sticks out 1/2" from the wall. Works with 2-wire…

view full answer...

Answer 12

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Will the 2-Wire RV Propane Gas and Carbon Monoxide Detector Work for Butane

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching