When Does the Life Span of a Carbon Monoxide Detector Start

Question

Question:

I understand that the AT31011 is no longer being made. An Rv parts department that I contacted has some still in stock. Because these units are built with end of life time limitations are these units already expired? How are the years of use calculated? Thank you

asked by: Judith M

0

Expert Reply:

Typically the life span of the carbon monoxide detectors doesn't start until the first power up. So they are most likely still good. We also carry detectors for gas and carbon monoxide should they no longer have any.

RV Propane Gas and Carbon Monoxide Detector # RS54FR

expert reply by: Scott S

0

Answer 1

This has happened a few times before with the 2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - Black #RS54FR, where someone replaces their old non-functioning alarm with a new one, but the new alarm appears not to work when the RV is…

view full answer...

Answer 2

The 2-Wire RV Propane Gas and Carbon Monoxide Detector part #RS54FR is not designed for butane but I spoke with the manufacturer and they said if the levels are high enough it will detect this and signal an alarm. The power draw is minimal, 17mA.

view full answer...

Answer 3

I recommend the #RS34FR to replace your current LP gas detector. This is a simple 2 wire design making for easy installation.

view full answer...

Answer 4

As far as specs go the Automatic Changeover RV LP Gas Regulator #37207-30395 is what you need to replace your Winntec 6020 regulator. When it comes to the mounting bolt pattern this regulator has a pattern of 1" horizontal x 3-1/4" vertical…

view full answer...

Answer 5

I wasn't able to find the Atwood 36720 RV Propane Gas Detector you mention, however I was still able to find the RV Propane Gas Detector #RS64FR in white, or #RS44FR in black to work as a replacement for your Protechtor Series 2001 LP Gas…

view full answer...

Answer 6

While we do have some carbon monoxide and propane alarms, we do not specifically carry the Safe-T-Alert 70-742. This is because we do not carry Safe-T-Alert products. With that being said, we do have the RV Propane Gas and Carbon Monoxide Detector -…

view full answer...

Answer 7

Much of this project will need to be completed with threaded iron pipe, flexible copper tubing, and fittings for iron and copper. We do not carry those parts or have expertise in that specific area. However, we can provide you some of the parts that…

view full answer...

Answer 8

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 9

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Answer 10

Atwood is no longer in business so you'd have to switch over to a new brand in order to get what you need. We currently only carry the RV Propane Gas #RS44FR (white #RS64FR) which comes with two different trims (large: 7-1/4" long x…

view full answer...

Answer 11

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 12

Based on what you are saying, it sounds like the detector is faulty and needs to be replaced; you did the right thing with vacuuming it and checking the batteries, as those are the two steps that need to be taken to ensure there isn't a…

view full answer...

When Does the Life Span of a Carbon Monoxide Detector Start

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching