Replacement Regulator for 2020 Jayco with 1 or 2 tanks

Question

Question:

I am looking for tank to regulator but my 2020 jayco has a bigger fitting on the regulator than the1/4 inch I find on any of the hoses I have found.

asked by: Jerry

0

Expert Reply:

If your Jayco has two tanks, as many do, then I would choose the MB Sturgis # 888001-MBS two stage regulator. I like that it has a mounting flange that attaches to the propane dual-bottle frame.

If your Jayco has only one tank then the MB Sturgis # 108220 will work for you as long as you can use the 1/4" female NPT inlet and 3/8" female NPT outlet which is pretty standard.

expert reply by: Les D

0

Answer 1

The MB Sturgis Propane Pigtail - Type 1 x 1/4" Male Inverted Flare - 5' Item #100575-60-MBS will connect to your regulator and propane tank and has a maximum flow capacity of 450,000 Btu per hour. If you need a smaller hose you can also use…

view full answer...

Answer 2

The Propane T-Fitting for Small Appliance #37207-30105 has an overall length of 4-1/4" long. With it screwed into a propane tank you will have around 3-5/8" sticking out depending on your valve on the propane tank. The POL Fitting…

view full answer...

Answer 3

Thank you for the photo it was helpful, and what it shows is you do have the standard dual propane tank set up, so you can absolutely use the MB Sturgis regulator you asked about: - MB Sturgis High Capacity Two-Stage Auto Changeover Regulator…

view full answer...

Answer 4

For a pair of 20 lb propane tanks, I recommend an option from MB Sturgis: - MB Sturgis High Capacity Two-Stage Auto Changeover Regulator #888001-MBS This regulator has a pair of 1/4" female inverted flare inlets and you can connect your propane…

view full answer...

Answer 5

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the necessary…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

100lb propane tanks typically have a female POL fitting so you'll just need to swap over the hoses to ones that have a male POL fitting and can still connect to your regulator/piping the same way the current hoses do. Most regulators have a 1/4…

view full answer...