Can I Use the Jack-It-2 on a Gulfstream Vista Cruiser 19ERD

Question

Question:

Hi, Wondering if the Jack-It-2 will work on on a Gulfstream Vista Cruiser 19ERD Travel Trailer? if it does the 22 1/2 height? Thanks! looks like a great option for bikes!

asked by: Scott W

0

Expert Reply:

Yes. It looks like the Gulfstream Vista Cruiser 19ERD has an A-frame with a jack at the front, so the Jack-It 2 Bike Rack for A-Frame Trailers - 22-1/2" Jack Clearance # LC429756 would be a great solution to carry bikes.

If your jack sits higher than that from the frame, let me know and I can look for an alternate solution for you.

expert reply by: Erik B

0

Answer 1

Since you have a 2022 Gulf Stream Vista Cruiser, it sounds like you are likely wanting to get a smoother ride rather than replacing leaf springs. You can use a shock kit to accomplish that. I have included a couple shock kit options below. You just…

view full answer...

Answer 2

The Equal-i-zer Weight Distribution System #EQ37100ET that you referenced has a shipping weight of 109 lbs so it is a little hefty like the majority of WD systems out there. If you take away a few pounds for the shipping materials you are left with…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 6

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb capacity and…

view full answer...

Answer 7

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Answer 8

While I was unable to confirm the exact dimensions of the Norcold 1200LRIM, I think your current refrigerator to be 63-1/4 inches tall, 32-11/16 inches wide, and 24 inches deep. Please confirm this. The Everchill RV refrigerator with freezer drawer…

view full answer...

Answer 9

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 10

The dimensions I found for your Dometic RM1350 on Dometic's site show it being 64.26" T x 33.69" W x 29.50" D. the closest match to these dimensions we carry is the Everchill RV Refrigerator w/ Freezer Drawer - 16 Cu Ft - 12V -…

view full answer...

Answer 11

The Everchill RV Refrigerator w/ Freezer Drawer - 17 Cu Ft #WAY44FR is 67-1/2" tall and 28-1/2" wide.

view full answer...

Answer 12

Since you are using shore power, you can replace your Coleman with an Advent 15,000 Btu unit and just need the wiring adapter. I really like the low profile units so I recommend going that route, and you can choose from either White or Black in…

view full answer...

Can I Use the Jack-It-2 on a Gulfstream Vista Cruiser 19ERD

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching