Replacement Leg and Foot For Heavy Duty Trailer Jack with 3-5/8" Square Tube
Question:
Im looking for a replacement leg and foot for a heavy trailer jackprobably 10-12K. Square tube, 3-5 /8. Approximately 18 long, maybe longerthe bottom end is crushed so hard to measure. 1-1/8 holes on both sides.
asked by: Patrick D
Expert Reply:
I may have a solution for you if you've got the Curt square jack part 28512, which is rated for 10,000-lbs, but it's the only solution we have that comes close to your specs. Have a look at the Replacement Inner Tube with Drop Leg, Foot, and Pull Pin for Curt Heavy Duty Direct Weld Square Jack # C28957 measures 28 inches tall and 3-1/2 inches wide. This would be the closest heavy duty replacement leg and foot for a jack of that size that we currently have available.
If you can find any identifying information on the jack that has been damaged I might be able to locate something else that would work.
Product Page this Question was Asked From
Replacement Inner Tube with Drop Leg, Foot, and Pull Pin for Curt Heavy Duty Direct Weld Square Jack
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Square, Direct Weld Jack Inner Tube with Spring-Return Drop Leg
- Shop: Replacement Inner Tube with Drop Leg, Foot, and Pull Pin for Curt Heavy Duty Direct Weld Square Jack
- Q&A: How To Re-Assemble The RAM TJD-12000SP Trailer Jack
- Shop: Buyers Products Heavy-Duty 4" Square Jack w/Front Pin Drop Leg - Sidewind - 26" Lift - 12K
- Shop: Square Jack Follow Leg - Side Pin Drop Leg - Spring Return - 25K Lift - 24-1/2" Travel
- Shop: Landing Gear Follow Leg - 16" Travel - 25,000 lbs
- Shop: Bulldog Square Jack - Fixed Leg - Sidewind - 12-1/2" Lift - 10,000 lbs
- Search Results: 40k hitch
- Search Results: 40 000 lb hitch
- Video: Bulldog Square Jacks Rebuild using Replacement Screw and Nut Assembly
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Search Results: 25580
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 44649
- Q&A: Seal With Dimensions to Replace 171255UC
- Shop: Trailer Wiring
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Search Results: dust cap
- Video: Titan Trailer Brakes T2385200 Review
- Article: Trailer Tire Sizing
- Shop: Fifth Wheel Hitch
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Dexter Suspension Kit 7753400
- Search Results: 68149
- Shop: Brake Controller
on Accessories and Parts
