Winch Mount Recommendation for 2000 Polaris 500 Sportsman With Double Tube Bumper

Question

Question:

I got the Superwinch Terra 4500 winch for Christmas, Im having a lot of troubles finding a mount for my 2000 Polaris Sportsman 500. I do have the double tube bumper but will remove it if necessary. Can you please help me with finding a mount for my 4 wheeler?

asked by: Daniel P

0

Expert Reply:

After consulting Superwinch I can recommend the ATV Mount # BDW15157 you referenced for your 2000 Polaris 500 Sportsman. It is a custom-fit winch mounting plate compatible with your ATV with all mounting brackets, hardware, and instructions included.

To use this mount for your ATV, you may need to mount your roller fairlead to the double-tube bumper or remove the bumper depending on the configuration of the bumper on your Sportsman 500. A co-worker here has a winch mounted on a 2002 Polaris Sportsman 500 HO Remington Edition and he utilized the double-tube bumper with his winches roller fairlead.

expert reply by: Brandon M

0

Answer 1

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution. It's correct length at 23-1/8 inches and is for a 3,500 lb trailer axle like you have as…

view full answer...

Answer 2

I took a sample of the Erickson Bolt-On Re-Tractable Ratchet Straps #EM34417 from our warehouse so that I could take the measurements you asked about. I prepared a photo for you to illustrate the measurements of the main ratchet housing and the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Winch Mount Recommendation for 2000 Polaris 500 Sportsman With Double Tube Bumper

Product Page this Question was Asked From

Continue Researching