Solution for Trailer Coupler - Adjustable Channel Mount # CTA-280 Needing Squeeze Latch  

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Instead of using the Hydraulic Brake Kit #AKFBBRK-35-D which requires using 14"-16" wheels you should use the Dexter Galphorite Free-Backing Hydraulic Trailer Brake Assembly Right #T4423400 and Left #T4423500. These will fit with your…

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

In order to install a brake controller on your 2007 Ford Expedition you will want to use the Adapter 4-Pole to 7-Pole and 4-Pole part #37185 as this will give you both 4 and 7 way connection points on the rear of your vehicle. The rest of the wires…

I pulled up the owners manual of your 2014 Ford F-150 and it looks like fuse number 67 is the trailer running light circuit so that would be the one you would need to check. It takes a 20 amp fuse.

The Atwood 87701-SP three-switch panel that you referred to is now obsolete, no longer made, and none in stock. The only wiring information I could find for you is a poor quality drawing from Atwood/Lippert which I have attached. We do not have this…

We do actually have Dexter electric drum brakes in your required 10 x 1-1/2-inch size, parts #K23-473-00 and #K23-472-00, which are right- and left-hand, respectively. These are complete bolt-on (4-bolt) replacements that fit wheels diameters from…

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down until…

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…