Which SnapPad Prime to Use for 2014 Fleetwood Discovery

Question

Question:

Can you tell me which Snappads would fit my 2014 Fleetwood Discovery with Powergear leveling system. Snappad tells me the Prime would fit but you dont use the same language as they do and I cannot find a model number on their site. Thanks

asked by: Cynthia L

0

Expert Reply:

The SnapPad Prime size is the 10 inch round octagon size part # SP64FR84 which is a 4 pack and the correct fit.

expert reply by: Jameson C

0

Answer 1

The SnapPad Prime size is the 10 inch round octagon size part #SP64FR84 which is a 4 pack and the correct fit.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 4

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

view full answer...

Answer 5

In order to actuate the trailer brakes, you'd need a brake controller installed in the vehicle and a 6 or 7-way trailer connector. A 4 pole flat wiring harness like the #18002 you'd looked at carries 4 circuits- right turn/brake lamp, left…

view full answer...

Answer 6

Hey John, the Tire Linc One Control part #LC37VR would be a great option to allow you to monitor the Wrangler's tire pressure while it's being flat towed. This comes with a signal repeater to help with longer setups like what you have as…

view full answer...

Answer 7

I do have an option for you but I don't have any way to reduce the ground clearance of your existing a-frame jack . That said, what you can do to fix this issue is replace your existing jack with the Ultimate Trailer Jack part #322-RDJ-2K. The…

view full answer...

Answer 8

Hi Mike, good question so I checked directly with Firestone for you and can verify that yes, the Ride-Rite air springs you asked about do fit the 2024 Chevy Silverado 2500 ZR2. The correct part number is the following: - Firestone Ride-Rite Air…

view full answer...

Answer 9

For octagonal jack feet we currently only offer 10" pads with part #SP64FR84. I recommend measuring the diameter of your 2023 Entegra Vision 27A's jack feet to confirm fitment. If you find you have a different size then let me know and…

view full answer...

Answer 10

The 101000156 part number you reference has to do with a motor which fits a variety of systems. In order to determine which replacement leg you're going to need for your landing gear, I am going to need to know what specific system you have. For…

view full answer...

Answer 11

You will want to measure the overall diameter of your landing gear feet, so you will want to include the "lips" as shown in the accompanying photo. The SnapPad Jack Pads for Class A and C Motorhomes w/ 10" Round and 10" Octagon…

view full answer...

Answer 12

I spoke with Furrion about the Furrion Microwave FMSMA15-SS and they informed me that the Furrion Over the Range RV Convection Microwave part #FMCM15SS is the correct replacement. I verified all of the dimensions and power ratings for you as well to…

view full answer...

Which SnapPad Prime to Use for 2014 Fleetwood Discovery

Product Page this Question was Asked From

Continue Researching