Replacement Lid Lifter for Thule Motion 800 Cargo Box

Question

Question:

Hello I am in need of a replacement hinge / lid lifter for a Thule Motion 800. The rear hinge has broken, do you have these parts available?

asked by: Alan D

1

Helpful Expert Reply:

It looks like the Thule Motion 800 is a UK-based box, and when I researched the two, it looks to be a counterpart to the Thule Motion XT XL in the U.S. The two boxes do share the same lid lifter, so the replacement you need for your Thule Motion 800 is the Replacement Lid Lifter Hinge for Thule Motion XT Cargo Boxes # 1401495200.

expert reply by: Kyle S

1

Answer 1

I have a great solution for you. Unfortunately, I confirmed with Thule that the Replacement Lid Lifter Hinge for Thule Cargo Boxes #TH14936 is not compatible with the Thule Motion XT XL #TH629806. However, the part that you need is the Replacement…

view full answer...

Answer 2

According to Thule, the proper replacement lid lifter for the Thule Motion XXL cargo box is their part number 1500056463 which we carry as part #1401495600. Just to be sure, I've confirmed this with my Thule representative.

view full answer...

Answer 3

Installing a replacement hinge or strut on your Thule rooftop cargo box isn't complicated, but it does take some force. I have added a link to a video showing how to do this, and you can forward to about the 1:30 part to get to the nitty gritty.…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

The best hitch receiver for hauling a bike with your 2022 Subaru Ascent is going to be the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" item #C25VR. This hitch receiver mounts behind your rear bumper bar instead of below your…

view full answer...

Answer 9

The connector you are looking for to install the Curt trailer wiring kit part #C56040 on your 2019 Subaru Ascent is located behind the driver side rear panel in the cargo area. If you check out the picture I attached you'll see where to find it.

view full answer...

Answer 10

I might have some options for you but I wasn't able to reference the TDE Turbo Lube 48395 Oil Cap. Therefore, in order to find a replacement for this you'll need to measure the outer diameter of the threaded portion on the oil cap. The Oil…

view full answer...

Answer 11

Though we do have the Bearing Buddy #BB2441T-SS that is a direct replacement for Tie Down's Turbo Lube oil baths, this will require you changing over to grease instead of oil. With that said, we do also have the Kodiak XL ProLube Kit…

view full answer...

Answer 12

Both the Rhino-Rack Vortex Aero and Thule WingBar roof rack systems have very nice features and would work well for your 2014 Hyundai Santa Fe. Both systems are designed to work on vehicles that have the flush mounted rail system. As far as the…

view full answer...

Replacement Lid Lifter for Thule Motion 800 Cargo Box

Product Page this Question was Asked From

Continue Researching