Camper Tie-Downs for a 2006 Ford F-350 Super Duty with a 6-3/4 Bed and a Factory Installed Hitch

Question

Question:

Hello, Ive got a 2006 F-350 SRW with 6.75 bed. Im trying to figure out what I need to get truck camper tie down points that would work for this vehicle. Any assistance is appreciated. Thanks

asked by: Austin

0

Expert Reply:

It looks like your 2006 Ford F-350 with the 6-3/4' bed has no rails under the bed and a factory installed hitch. For this configuration, you have two options, depending on the hitch.

If your hitch has an open-ended crosstube, then the TorkLift set is your best option, part # TLF2007 for the front and part # TLF3004 for the rear. These tie downs do not require drilling, making them the easier installation. I've linked to video reviews of both.

If your hitch does not have an open-ended crosstube, then you need the HappiJac Tie-Down, part # LC182910-182971. This one only attaches in the rear, but requires drilling into your truck, so it's a more difficult installation. I've linked to a video review of this tie-down as well.

Keep in mind that you will need turnbuckles for either of these. I've linked to a list of our turnbuckles, but a good one for the TorkLIft is part # TLS9013, and a good one for the HappiJac is part # LC182898.

expert reply by: Kef G

0

Answer 1

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 3

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory…

view full answer...

Answer 4

Hey Robert, sorry it can be a bit confusing navigating all those facets for the camper tie downs, but I did go ahead and find those tie downs you were looking for. For the front, you'll want the TorkLift Camper Tie-Downs #TL87CR (TorkLift…

view full answer...

Answer 5

Of the two part numbers you mentioned only the #TLF2022A is a fit for your 2022 Ford F-350 short bed without factory board and with the factory installed hitch. You might have meant to type #TLF2022 which is the non-aluminum/stainless steel option…

view full answer...

Answer 6

The 1-5/16" Hellwig Adjustable Big Wig Rear Anti-Sway Bars are designed for 2WD #HE97MR or 4WD #HE94FR versions of your 2021 Ford F-250. These are both designed for trucks which have a stock ride height. Hellwig does offer their 2"…

view full answer...

Answer 7

The F2032 you're looking for is under part #TL87CR on our website and would be the correct fit for your 2024 Ford F-350. For the rear tie-downs you'll need part #TLF3008. To complete the setup you can use the TorkLift AnchorGuard Derringer…

view full answer...