Replacement 2-Way Connectors for Winch Connection Made to Wiring  

There is only one dust cover offered with the Bulldog Winch Quick-Connect Set for Powersports w/Dust Cover #BDW20047 is because the end where you'd use the included dust cover would also be connected to the battery and if water got in it…

I did some searching around on the internet and came up with a few interesting tips to prevent rodents from eating vehicle/trailer wiring. Here is what I found: Noise will keep the rodent's away. So a portable radio would work for this.…

I have a solution for you to maintain your trailer's battery while towing, but we do not offer an aux socket adapter for your battery charger from Schumacher. There is not a great way to charge your trailer's battery while towing, but you can…

The Bulldog Winch quick connectors #BDW20047 themselves do not have any sort of cover to protect them from the elements. But what you could do is modify mounting box #RP74641 and that will help protect them. There is no one place that you have to…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…