Replacement Motor and Blades for Ventline Ventadome V3094

Question

Question:

Looking for a replacement fan motor for my v3094 dexter ventadome and blades if needed. Is this the correct part?

asked by: David M

0

Expert Reply:

Yes. If you've got a Ventline E-Z Lift Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - Smoke - Canada Approved # V3094-603-00C, which is the same as the V3094 you mentioned, then the Replacement 12V DC Motor for Ventline, Ventadome, and Vanair Fans # BVD0218-00 is the correct replacement motor. If you also need the fan, that can be replaced with the Replacement Fan Blade for Ventline E-Z Lift Ventadome Trailer Roof Vents # BVE0114-00.

expert reply by: Erik B

0

Answer 1

All of the fans and fan motors that we offer are replacement items for roof vents that came with fans. If the roof vent in your trailer did not come with a fan, then you may be able to add a fan, but you will likely have to fabricate a mount for the…

view full answer...

Answer 2

Since you have a Ventline V2394 the correct screen/frame you'd need is the part #BVC0573-31R.

view full answer...

Answer 3

I do have a possible solution for you, however there is not going to be an option to upgrade only the housing and fan you'd have to do a complete swap. With that being said, a great upgrade for your discontinued Dometic EZ-Breeze is the…

view full answer...

Answer 4

I do have an option for you but I don't really know what you mean by removable, all trailer roof vent fans can be removed but you'd have to break the seal on the roof each time for any of them. Anyway, if you're looking for exhaust…

view full answer...

Answer 5

For your Ventline E-Z Ventadome Trailer Roof Vent #V3094-601-00, the correct replacement fan blade is the Replacement Fan Blade for Ventline E-Z Lift Ventadome Trailer Roof Vents #BVE0114-00.

view full answer...

Answer 6

Your Ventline roof vent part number 2394 is the older style Venline roof vent I believe and would require the part #BV0554-01 as a replacement cover. If you happen to have a different roof vent cover style check out the link I attached that shows all…

view full answer...

Answer 7

The motor you'd looked at, part #BVD0218-00 is the correct replacement for your range hood. I've confirmed this by forwarding your photo to the folks at Ventline.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...