Does Solera 12 Foot Replacement Awning Fabric Have Light Cord for Fabric Light Kit

Question

Question:

The ad does not state whether it has the light track. I already own the light kit.

asked by: Stacy

0

Expert Reply:

I verified with the manufacturer that the light cord/track is present in the Solera 12' Replacement Awning Fabric - White Fade # LCV000334356.

This will allow you to slide in the light kit you mentioned, which is the LED Fabric Light Kit with Switch/Plate for Solera RV Awning # LC674282.

expert reply by: Kyle S

0

Answer 1

If you just need the replacement LED strip, then you&#39;ll just need the Replacement LED Light Strip for Solera RV Awnings #LC423331 and cut it down to fit your 14&#39; awning. If you are wanting to add a LED strip to an awning that…

view full answer...

Answer 2

For a 12 foot awning the part #LCV000334919-362241 would be exactly what you&#39;d need and then to add an LED light kit you&#39;d need the part #LC674282 as well and you&#39;d be set.

view full answer...

Answer 3

I did some online research and your 2021 Keystone Montana High Country 331RL comes pre-wired for the top of the line SolarFlex system. This SolarFlex system is a 1,200 watt system with 4, 300 watt solar panels. Our comparable system is the Go Power…

view full answer...

Answer 4

I went ahead and double checked to be sure, and yes the 7-Piece Installation Set for Bearings, Races, and Seals #PTW83020 you mention will work with your Timken bearings, races, and seals. If you don&#39;t have grease yet, you&#39;re…

view full answer...

Answer 5

The bearings can be tapped into place but it is a great idea to use a tool to make sure it is done correctly. The tool we offer is part #PTW83020. This includes six discs that will work with common bearing sizes. They are 1.565&quot;,…

view full answer...

Answer 6

The Dexter Trailer Brake Assemblies 023-476-00 will cross-reference to our Dexter Electric Trailer Brake Kit part #K23-472-473-00.

view full answer...

Answer 7

The part of a hub/drum assembly that makes contact with the electromagnet, the armature surface, cannot be machined. If the surface is deteriorated you'd do well to replace that hub. The link provided will show you all hub/drum assemblies…

view full answer...

Answer 8

It sounds like your problem may be that you are installing too much grease into the hubs and that is why they are blowing out. If you are pumping your grease into your hub with a grease gun you should note that you should only continue to add…

view full answer...

Answer 9

As long as your spindles are 4.75 inches from seal to threading like #TRU24FR or #TRU57FR they are compatible. I've attached a photo to assist. You will be able to use the Electric Trailer Brake Kit - Self-Adjusting - 10" - Left and…

view full answer...

Answer 10

The closest thing we have to your jacks are the Ultra-Fab Ultra Scissor Jacks - 24" Lift - 6,500 lbs - Qty 2 #UF48-979002. These are BAL jacks that have a restricted height of 4-3/4 inches and an extended height of 28-3/4 inches.…

view full answer...

Does Solera 12 Foot Replacement Awning Fabric Have Light Cord for Fabric Light Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching