Should There Be Slack In a B&W Companion Hitch When Installed In a B&W Turnoverball  

For your 2013 Ford F-250 short bed that has a B and W Turnover ball gooseneck hitch installed in it already the Slider Companion part #BWRVK3400-5W would be perfect for you. The Companion hitches are considered to be the nicest fifth wheel hitches…

No. Since the Companion hitch has a square tube that mounts into a gooseneck connection you will only be able to mount a B&W Companion hitch like the #BWRVK3500 in the gooseneck ball mount of the B&W Turnoverball like #BWGNRK1012.

If you have a bedliner it's going to need to be trimmed to install the B and W Companion #BWRVK3400. It needs to make a solid connection to the bed of your truck and if you have a slide in bed liner that would get in the way.

The B&W Companion mounts in the B&W Turnoverball that doubles as a gooseneck hitch and will not mount on other goosenecks. B&W is a very high-quality hitch and you are right to prefer them but the only way to install a…

When installing the pivot arms on your B&W Companion #BWRVK3400-5W you'll need to measure from the ground to the floor of your bed and from the ground to the plate of the pin box on the trailer down to the ground while it's…

The adjustable ribs on the Base #BWRVB3405 of the B&W Companion Slider 5TH Wheel Hitch #BWRVK3400 do not have to fit fully into the bed grooves. Do be sure to tighten the hitch down properly inside the Turnover ball gooseneck hitch.

The two B and W Companion hitch part numbers you mentioned are the exact same. We just need the same hitch to appear in two fitguides so the part #BWRVK3400-5W shows up in the fifth wheel fitguide and the #BWRVK3400 shows up in the gooseneck fit…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the…

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…