Compatibility of Timbren Suspension for Light Duty Trailers on 1957 Cardinal Travel Trailer

Question

Question:

My 1957 Cardinal travel trailer bounces and rolls quite a bit when traveling over the slightest bump. Can you recommend a solution given the measurements shown in my photo? Note: the trailer SN: W1426 is all original including the springs, but usage over the past 63 has been minimal until now. Thanks!

asked by: David

1

Helpful Expert Reply:

The Timbren Trailer Suspension Enhancement System Light-Duty Trailers 1,000 lbs # TTRA1702 will be a great help in reducing body roll and helping dampen the bounce. Based on your measurements this will immediately take on load and stabilizing while still having room for suspension movement and further assistance so it is a great option for you.

expert reply by: Jason S

1

click to enlarge

Answer 1

The Timbren Trailer Suspension Enhancement System #TTRA1702 is 2-3/4" tall with no load on the spring. This particular system is designed to mount to the frame with the included bracket(see image) and when the suspension compresses the axle will…

view full answer...

Answer 2

For the Thule Force XT Sport Rooftop Cargo Box #TH6356B to allow the hatch on your 2016 Honda CR-V to fully open without interference you need to have at least 48-1/4" from the middle of your forward most crossbar to the line where your roof and…

view full answer...

Answer 3

I went out to the warehouse and pulled the Replacement Square-Bar Clamp-On for Thule Ride-On Adapter #853-2156 and found that it is 1-1/8" wide by 1" tall and the Thule Square Bar Adapter for Fairing #853-7362 is 1-7/16" wide by…

view full answer...

Answer 4

Thanks for the pictures! Based on that it looks like you have a Thule Flat Top and need the part #7533998 to allow it to fit aero bars.

view full answer...

Answer 5

Unfortunately Timbren does not make their Timbren Active Off-Road Bumpstops #TABSOSR kit without the axle bracket, so if you don't need it you'll just ignore it and install everything else. To figure out if you need a spacer kit #T68MR…

view full answer...

Answer 6

For your 2018 Chevy Colorado ZR2 Diesel I recommend RoadActive Suspension #RAS4617. This system will provide extra support when towing and/or carrying loads in the truck bed as well as help with overall stability all without affecting the unloaded…

view full answer...

Answer 7

A trailer can bounce if there is not enough weight on it. You see this particularly with utility trailers that are empty. The tire and wheel size would not automatically cause a trailer to bounce though usually you see smaller tires on smaller…

view full answer...

Answer 8

For suspension enhancement on your trailer you'll want a Timbren spring for trailers like #TTRA1702 which measure 2-3/4 inches high. I've also linked our selection of Timbren springs for trailers for you.

view full answer...

Answer 9

It sounds like you may need to look into the state of the suspension on your trailer. If there is so much movement that it has caused the tires to damage the fenders then something is not quite right. The Timbren springs like #TTRA1702 are designed…

view full answer...

Answer 10

The Timbren Trailer Suspension Enhancement System Light-Duty Trailers 1,000 lbs #TTRA1702 have a combined rating of 1000lbs, and not 1000lbs per spring. Since your leaf springs are supporting the weight on the axle, suspension enhancement like this…

view full answer...

Answer 11

For your 2015 Nissan Frontier I would recommend the SumoSprings Solo Custom Helper Springs #SSR-610-40, which are the blue SumoSprings. Although SumoSprings are pretty good about not affecting your unloaded ride quality you're right, the others…

view full answer...

Answer 12

The jounce spring of the SumoSprings Solo Custom Helper Springs #SSR-610-40 measures 4 inches tall; they are also 3 inches in diameter. These springs are a direct fit for your 2012 Nissan Frontier. I have added a link to a video review for you to…

view full answer...