My Motion Lighting Security Light is Malfunctioning

Question

Question:

I have just purchased a travel trailer with these lights along the floor. I found that i have one that is turning off and back on every ten seconds with no motion in camper. any tricks of what might be causing this ?

asked by: Philip K

0

Expert Reply:

It sounds as if the motion sensor in the LED RV Security Light part # CE76FR has malfunctioned. In this case it is likely better to replace it unless you are handy with electronics and are able to check the inside for a shorted wire that could potentially be repaired.

expert reply by: Randy B

0

Answer 1

It sounds as if the sensor on your LED RV Security Light part #CE76FR has failed and the light will need to be replaced. I have seen this before but it is not very common. For some reason your sensor is telling the light it sees motion when in fact…

view full answer...

Answer 2

Currently the LED RV Security Light #CE76FR is the only 12 volt powered motion activated light that we have that would work for your 2020 Keystone Cougar 268MBI in your entry way. While it does not have a switch you could add a Mini-12V Switch…

view full answer...

Answer 3

The cover of the LED RV Security Light #CE76FR snaps over the main body of the light. On the top and bottom of the light there are little tabs you can use a flathead screwdriver to pry on and pop the cover off.

view full answer...

Answer 4

We have exactly what you're looking for with the LED RV Security Light #CE76FR! This is powered via 12V power as opposed to the solar options and it uses the motion detector so you'll get the light when you're near your stairs. Attached…

view full answer...

Answer 5

There could be a couple reasons why your motion detector, like the LED RV Security Light #CE76FR is malfunctioning. One cause could be a short somewhere in the circuitry. In this case, you're going to need to replace the entire sensor, unless you…

view full answer...

Answer 6

For a white motion detector light I recommend the Solar Powered LED Porch Light for RVs #DG0168. This light has both motion detection sensor mode and dusk to dawn sensor mode to provide lighting, safety, and security. It is solar powered so you…

view full answer...

Answer 7

The LED RV Security Light, #CE76FR, is a motion detected exterior light designed to mount on the surface of your RV using hardware in each corner of the base of light fixture and then installing cover.

view full answer...

Answer 8

5th wheel hitch base rails require direct metal-to-metal contact with your truck's bed. It is possible to install a 5th wheel hitch on a truck that has a drop-in bed liner like the WeatherTech #WT38209 but it is necessary to cut out openings in…

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

My Motion Lighting Security Light is Malfunctioning

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching