Can Manual Key Be Used with Pop and Lock Power Tailgate Lock # PAL9772

Question

Question:

If I use the 9772 kit, can I not still use manual keys also. My handle looks just like the pop and lock replacement handle. Looked at PAL web page, appears to be direct add on. I am confused.

asked by: Johnny H

1

Helpful Expert Reply:

Yes when you install the Pop and Lock Power Tailgate Lock # PAL9772 you can still use your manual key as well.

expert reply by: Jameson C

1

Answer 1

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

view full answer...

Answer 2

Yes, the Pop & Lock Power Lock Conversion Kit #PAL9772 that you referenced will fit your Jason hard tonneau cover!

view full answer...

Answer 3

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 can install and be used with your existing tailgate lock you have from Pop and Lock. It ties into the same circuits your tailgate lock ties into so you…

view full answer...

Answer 4

The Pop & Lock Power Lock Conversion Kit #PAL9772 can be used with an ARE topper provided it has a cable latch assembly and a 1-1/8" center hole. It will allow you to lock and unlock using your trucks key fob.

view full answer...

Answer 5

You're just trying to get the lock/unlock signal so if you could splice into the wire(s) in a closer location to the tailgate when installing the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 that would…

view full answer...

Answer 6

So long as you have the Leer 100XC truck cap, the correct Pop & Lock is the following: - Pop & Lock Power Lock Conversion Kit #PAL9772 I verified this with the manufacturer for you.

view full answer...

Answer 7

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 8

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Having the extra amperage of the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K has no down side. You'd at worst just have more power available than you'd need.

view full answer...

Answer 11

I spoke with my contact at Progressive Dynamics and they informed me that the Lithium Converter for WFCO RV Power Centers part #PD4655LIV does work as an upgrade for the Parallax 7355. It has the same housing as the Replacement Converter for…

view full answer...

Answer 12

You'd need a new panel like the Progressive Dynamics Mighty Mini part #PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible. There isn't a center section replacement available for what you have that…

view full answer...

Can Manual Key Be Used with Pop and Lock Power Tailgate Lock # PAL9772

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching