Fit of Draw-Tite 65049 Front Hitch Receiver on 2014 Ford F-350

Question

Question:

Is it possible to mount part number 65049 on a 2014 Ford F-350? Will this product fit?

asked by: Andrew

0

Expert Reply:

It sure will fit. The Draw-Tite # 65049 front hitch will fit both 2WD and 4x4 models of the 2014 Ford F350. On 4x4 models, some minor fascia trimming will be needed.

expert reply by: Mike L

0

Answer 1

We have a great font hitch for your 2016 Ford F-250 Super Duty. It's the Draw-Tite 2" Hitch, part #65049. It works for both 2-wheel and 4-wheel drive models and has an easy, bolt-on installation. It has a line pull of 9000 pounds, a vertical…

view full answer...

Answer 2

When installed, the EcoHitch #EH59FR front receiver will sit in the middle of the front bumper, between the tow hooks as shown in the photo I've provided for you. With the receiver sitting in the middle of the bumper, you won't need to worry…

view full answer...

Answer 3

Yes the install of the Curt front hitch part #C31014 on your 2003 Ford F-250 does use the front leaf spring bracket like you mentioned. I attached a picture I took from the install instructions (also linked) that shows how it all goes together.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hi Kris, TorkLift lists part number #EH54QR as a fit for a 2023 Ford F-550. The #306-X7904 is not listed as a fit for an F-550 at all but we've confirmed it on our site because F-350 owners were trying it and it fit. Most likely it could fit but…

view full answer...

Answer 6

Yes, it will so long as your 2023 Ford F-350 doesn't have dual rear wheels. It won't work with the dually models since there is a larger front mounted auxiliary cooler that interferes with installation. The EcoHitch Hidden Front Hitch item…

view full answer...

Answer 7

I checked with Furrion and confirmed the Furrion 2-in-1 Range Oven with Glass Cover part #FR97KR has an enamel stamped removable grate, not die cast.

view full answer...

Answer 8

Yes, the glass top on the Furrion 2-in-1 Range Oven #FR97KR is removable. The hinge for the glass has a small Phillips-head screw with a Phillips-head cap on it (pictured below) that can be removed to take the glass top off.

view full answer...

Answer 9

I did some research and found instructions for installing the RanchHand Legend Grille Guard on your 2011 F-250 4x4. You can check out the attached photo that shows where a front hitch is mounted on a Ford F-250. You may find that the bottom bar on…

view full answer...

Answer 10

There are going to be two parts to the handle that you will need to operate the Lippert Components Spare Tire Winch part #LC159056. The first of which is the intermediate shaft or what Lippert calls a Crank Extension part #LC1315411. This will be…

view full answer...

Answer 11

For your 2008 Ford F-350 we have the Draw Tite hitch part #65049 which is a confirmed fit and has a tongue weight capacity of 500 lbs. The motorcycle carrier we offer that would work best is the Ultra Fab part #UF48-979033. Reason being it weighs…

view full answer...