Could Plug of Progressive Dynamics Converter be Hardwired to RV Inlet

Question

Question:

I have a 30 amp inlet installed, with 3 wires running from it into our electrical space. Am I able to cut the plug on this unit and hardwire it to the inlet wires?

asked by: Ian

0

Expert Reply:

If you wanted to hardwire the Progressive Dynamics Inteli-Power RV Converter and Battery Charger # PD9130LV to the inlet on your RV you could cut off the plug and wire directly if you wanted. I'd recommend having an electrician help you.

expert reply by: Jameson C

0

Answer 1

The Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9130LV is compatible with Lithium batteries and has an output of 30 amps which would charge the battery quickly. In just a few hours your battery would easily be charged from a…

view full answer...

Answer 2

For your application I recommend going with the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9260C because it's a 60A model like your WFCO 9560 MBA and it has the built in charge wizard that is able to monitor your…

view full answer...

Answer 3

Though there may need to be some modifications needed to get it installed, the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 60 Amps #PD9260C will work as a good replacement for your WFCO WF-9855. One potential…

view full answer...

Answer 4

I don't have a fool proof way of selecting the proper charge converter amperage rating because it is not based solely off the battery capacity but rather this combined with the load the trailer uses. Therefore, the best option would be to go with…

view full answer...

Answer 5

We have two options that match the 30 amp converter you are replacing with the difference being what type of batteries you have. If they are lithium batteries you would need the Progressive Dynamics part #PD9130LV which charges at the higher voltage…

view full answer...

Answer 6

Yes, the Progressive Dynamics Inteli-Power RV Converters like part #PD9130LV must be grounded to the chassis which you can see from the photo below which was pulled from the installation instructions.

view full answer...

Answer 7

While we have no way of knowing what converter is in a Dutchmen Adirondack trailer, you can use the following: - Progressive Dynamics 9300 Series RV Converter Charger #PD49RR

view full answer...

Answer 8

The Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9130LV would replace the WFCO converter you have now. The #PD9130LV will give you ability to charge a Lithium battery like it sounds like you have so you'd have no use for…

view full answer...

Answer 9

Yes, the Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9130LV that you referenced will work great to charge up your 100 amp hour lithium battery. This charger has an output of around 30 amps so not only is it good for charging…

view full answer...

Answer 10

I don't have a fool proof way of selecting the proper charge converter amperage rating because it is not based solely off the battery capacity but rather this combined with the load the trailer uses. Therefore, the best option would be to go with…

view full answer...

Answer 11

Thanks for reaching out! You can technically keep your current converter on your '76 Robinhood Lazy Daze motorhome and use the new one solely for the battery bank, but I recommend just changing everything over at the same time since you'll…

view full answer...

Answer 12

You can replace your older WF-8735P converter with the Progressive Dynamics #PD9130LV converter and lithium battery charger. Yes, you could upgrade to a 60 Amp converter, but you would then have to replace your power center for larger service and…

view full answer...

Could Plug of Progressive Dynamics Converter be Hardwired to RV Inlet

Continue Researching