Replacement 30 Amp Converter For Travel Trailer

Question

Question:

I have a Dutchmans Adirondack 30RL and I need to replace the 30 amp converter.

asked by: David M

0

Expert Reply:

While we have no way of knowing what converter is in a Dutchmen Adirondack trailer, you can use the following:

- Progressive Dynamics 9300 Series RV Converter Charger # PD49RR

expert reply by: Kyle S

0

Answer 1

Manufacturers do not list the parts they use on their RV's so you would need to remove the back plate of your current door handle to measure the cutout hole. The Global Link RV Entry Door Locking Latch Kit with Keyed Alike Option #295-000019 you…

view full answer...

Answer 2

In the question and answer page you're referring to Kyle states that the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp #PD4635V could be used in to replace the converter section, but that it was only intended for…

view full answer...

Answer 3

On a 30 amp trailer with lithium batteries you will want to stick with the Progressive Dynamics 9300 Series RV Converter Charger #PD49RR. Only the amperage output is higher on the 40 amp converter; the efficiency is exactly the same for both.

view full answer...

Answer 4

You can replace your Elixir 45amp converter charger with either the Progressive Dynamics Inteli-Power RV Converter and Battery Charger - 12V - 45 Amps #PD9145A (flooded lead acid, AGM, and gel batteries) or the Progressive Dynamics Inteli-Power RV…

view full answer...

Answer 5

Yes, you can replace and upgrade your 30 amp converter with the 35 amp Go Power RV Converter and Smart Battery Charger #34266167. The 35 amps is its max output current so it will work for you as a replacement; I have added a link below to the manual…

view full answer...

Answer 6

The Go Power RV Converter and Smart Battery Charger #34266167 uses 40 amps at start up and runs at 10 amps. It is deigned to convert AC shore power to DC power to run 12v loads at the campground and must be plugged into a 120 V 3 wire grounded…

view full answer...

Answer 7

No, the Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9145ALV is only designed to convert AC current to DC current to charge the battery. What you're looking for is the Progressive Dynamics Mighty Mini AC/DC Panel and…

view full answer...

Answer 8

When you move up to a larger amperage converter you just need to ensure that your wiring is the correct gauge to support the higher amperage. Since you're only going from 40 to 45 amps you're more than likely fine. The next important step is…

view full answer...

Answer 9

The PD9140A converter you have will wire directly to the battery positive post and need to be grounded to the chassis and it appears that you have a mold plug coming out of the right side in the picture so you would need to run that to a dedicated…

view full answer...

Answer 10

That is a great question. The 12-volt accessory feed from the 7-way CAN be used to maintain your trailer-mounted battery during travel, but it will NOT recharge a battery from a depleted state. To charge a depleted battery, a charger like the…

view full answer...

Answer 11

The Progressive Dynamics 9100 Inteli-Power Lithium Converter - 12V - 45A #PD9145ALV only has power when the trailer is connected to shore power (110v AC). The power coming from your alternator is 12v DC and is totally fine to send through to the…

view full answer...

Answer 12

We have two options that match the 30 amp converter you are replacing with the difference being what type of batteries you have. If they are lithium batteries you would need the Progressive Dynamics part #PD9130LV which charges at the higher voltage…

view full answer...

Replacement 30 Amp Converter For Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching