Pressure Rating for Aluminum Liger Trailer Wheel # LH97FR

Question

Question:

I see the load rating but no pressure rating on the Lionshead Liger LH97FR wheels. Looking to upgrade tires and source an extra wheel but want to confirm rating.

asked by: Ian C

0

Expert Reply:

The Aluminum Liger Trailer Wheel # LH97FR that you referenced doesn't have a listed pressure rating because it's going to be the valve stem you install in it that will be the limiting factor in that regard. The valve stem of this wheel can handle 110 psi.

expert reply by: Jameson C

0

Answer 1

The Aluminum Liger Trailer Wheel - 16" x 6" Rim - 6 on 5-1/2 - Black #LH97FR you have installed on your trailer should not have a PSI rating as this is typically limited by the valve stem, not the wheel. As long as you are using a quality…

view full answer...

Answer 2

I would recommend to check the sidewall of your ST225/75R15 Load Range E tires to verify what the maximum load capacity is and at what maximum psi. Most of the load range E tires in that size are a 2,830 lbs at 80 psi. The HWT Aluminum Star Mag…

view full answer...

Answer 3

The left and right bottom doors are freezer. Top right door is refrigerator, and top left is wine storage. The wine chiller side of the Furrion RV Refrigerator part #FCR14ACBQABL is not adjustable as it preset to 12.8 degrees Celsius which is 55…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 6

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 10

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Pressure Rating for Aluminum Liger Trailer Wheel # LH97FR

Product Page this Question was Asked From

Continue Researching