Replacement Hitch Pin for Yakima BackRoad 4-Bike Rack

Question

Question:

what is the size of the hitchbolt for yakima backroad 4?

asked by: Donnie

0

Expert Reply:

I checked with Yakima and the correct replacement hitch pin you need for your BackRoad is the part # Y8890176.

expert reply by: Jameson C

0

Answer 1

For me there is one clear choice between the two bike racks you asked about, and for one very particular reason - convenience. Due to how convenient it is, I definitely recommend the RidgeBack, which is the following part number: - Yakima RidgeBack…

view full answer...

Answer 2

Since the lock number of your hitch lock is only listed on the side of the lock core, and yours is locked and therefore not accessible, the only solution is to replace what you have with a new hitch bolt and lock. For that you'd need part…

view full answer...

Answer 3

We don't carry BV products, so I couldn't say if any of the bike rack threaded hitch pins we offer would be a compatible replacement. If your rack has a 2 inch hollow shank and doesn't use an adapter, a universal option like #SHP2061…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The Tow Defender #RM-4700 you found is really our best option to protect the front of your 2024 Chevrolet Trax. This screen helps to deflect any road debris back down to the ground to keep it traveling under your Trax. This particular cover is…

view full answer...

Answer 12

Our etrailer Trailer Hitch Receiver #e27KR you found is our most economical custom fit receiver for your 2023 Honda Pilot Touring edition. For the wiring you can select from either the 4-Way #C48ZV or the 7-Way #C35ZV depending on the types of…

view full answer...

Replacement Hitch Pin for Yakima BackRoad 4-Bike Rack

Product Page this Question was Asked From

Continue Researching