Can V-Keel Rollers be used on a Wood Sea Wall to Move a Pontoon Boat
Question:
I have a Godfrey Sweetwater 18foot pontoon boat that needs a new carpet. I have waterfront property with a wood seawall only 12inch above the water level. Can I mount 2 V-Keel rollers on the seawall spaced equal to the center line spacing of the hulls to haul out my pontoon boat? The light weight of the boat is about 1400 lbs. I could strip most of the topside weight dockside if necessary. Would two rollers #811 work or would you recommend larger rollers?
asked by: Ed M
Expert Reply:
This could work but make sure the wall can handle it. The roller, # YR1000Y, does not have an official capacity but just for the ease of moving the boat on them I would use as many rollers as could fit. The issue is that since the entire boat is not supported at the same time, it could end up damaging the boat.
Another option is to construct a device like in the picture I have included using rollers, # DL21741, and some lumber. With this type of set up, it would be very easy to move the boat and it would be fully supported.
Products Referenced in This Question
Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers
- Boat Trailer Parts
- Bunks
- Rollers
- Roller Bunk
- Black Rubber
- Dutton-Lainson
more information >
Product Page this Question was Asked From
Yates Keel Roller for Boat Trailers - TPR - 10" Long - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Keel Roller
- 3-1/8 Inch Diameter
- Thermoplastic - Non-Marking
- 9-3/4 Inch Long
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Shop: etrailer Tongue Weight Scale for Campers and Utility Trailers - 2,000-lb Capacity
- Shop: Yates Keel Roller for Boat Trailers - TPR - 10" Long - 5/8" Shaft
- Shop: Ark Ezi-Guides Self-Aligning Boat Trailer Loading System - 14' to 16' Long Power Boat
- Article: How Much Does a Boat and Trailer Weigh?
- Video: CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10405G Review
- Shop: CE Smith Deep V Keel Roller Assembly for Boat Trailers - Galvanized Steel and Yellow TPR - 12"
- Shop: CE Smith Deep V Keel Roller Assembly for Boat Trailers - Galvanized Steel/Black Rubber - 12"
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Trailer Wiring Diagrams
- Shop: Grease Seals 10-36 (pair)
- Search Results: 44649
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Shop: Trailer Wiring
- Search Results: 68149
- Video: Choosing the Right Brake Controller
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: How to Choose the Right Trailer Hitch Class
- Video: Review of Ultra-Fab Products Camper Jacks - Landing Gear - UF17-943010
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Fifth Wheel Hitch
- Search Results: 25580
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Search Results: dust cap
- Video: Roadmaster Sterling All Terrain Tow Bar Inner Arm Replacement Installation
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Brake Controller
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Search Results: 44610