Will the AirLift 1000HD Air Helper Springs part # AL60828HD Help my 2019 Ram 1500 with 1,700 lbs. TW  

If the back of your 2016 Kia Sorento is squatting when pulling your trailer, I do suggest installing some suspension enhancement. The Air Lift 1000 Air Helper Springs for Coil Springs #AL29PD will supply a load-leveling capacity of up to 1,000 pounds…

For your 2022 Kia Telluride, we do have an option for you. The Air Lift 1000 Air Helper Springs for Coil Springs #AL29PD will fit all models of the 2022 Kia Telluride and provides up to 1,000lbs of load leveling support, that will help reduce tire…

Air Lift doesn't offer a 1000 system for a 2019 Ram 1500, so there's one large difference. The other is the capacity. The regular Air Lift 1000 system offers a capacity up to 1000 lbs, while the 1000HD system like #AL60828HD has a 2100 lb…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…