Single Bar Roof Rack for 2018 Ford F-250 Crew Cab

Question

Question:

I’d like to purchase the Yakima Long Arm Extender, height extension and a single bar roof rack for my truck. Please advise on which roof rack I should use with price options.

asked by: Rod

0

Expert Reply:

Rhino Rack roof rack crossbars and feet can be purchased so as to easily come up with a single crossbar roof rack but unfortunately the vehicle specific fit kits are sold in quantities of 4 clamps, so you'll end up with two extras.

To install a single crossbar rack on your 2018 F250 Crew Cab, I'd recommend going with the Vortex Aero crossbar. You'll need the following:

-Vortex Aero Crossbar, part # RRVA150S
-Vortex Aero Half Foot Pack, part # RRRLKVAH
-Vehicle Specific fit kit, part # DK498

You'd also mentioned the height extension for the # Y01149 Yakima LongArm, which is part # Y01150

expert reply by: Mike L

0

Answer 1

You have all of the correct parts aside from the fit kit (which is for an F-150). For your 2017 Ford F-250 Super Duty you'll need the following: 54" Vortex Crossbar - #RRVA137B 2500 Series Legs - #RRRLKVAH Fit Kit - #DK498 Fairing - #RRRF4…

view full answer...

Answer 2

The Rhino-Rack Pioneer Platform Rack with Backbone Mounting System - 60" Long x 56" Wide #RR93ZW will not require drilling into your 2017 Ford F-250 Crew Cab. You will remove factory bolts already present and reinstall them to secure the…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 8

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 9

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Single Bar Roof Rack for 2018 Ford F-250 Crew Cab

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching