Replacement Coupler and Driver Side Arm for Roadmaster Stowmaster RM-501

Question

Question:

Does this part also directly replace the drivers side arm on the roadmaster stowmaster RM501 tow bar?

asked by: Matthew H

0

Expert Reply:

We have the replacement coupler and driver side arm that does fit the Stowmaster # RM-501 with the part # RM-910018-00 but the part number you mentioned is not the correct fit.

expert reply by: Jameson C

0

Answer 1

Since your 2014 Chevrolet Equinox has a combined wiring system, which means brake and turn signals are sent along the same wire, you will need to use the Upgraded Circuit Protected Taillight Converter, #119178, in order for your brake lights to…

view full answer...

Answer 2

Yes, you can replace the 2" ball coupler of the StowMaster #RM-501 with the Replacement Coupler Arm Assembly for Roadmaster StowMaster with Lunette Ring #RM-C001890 for a 2-1/2" ID lunette ring.

view full answer...

Answer 3

The shortest pintle hook option we have is the Curt SecureLatch Pintle Hook for 2" Hitches #CU24FR which measures 9" from the center of the hitch pin hole to the center of the pintle hook. Please note that you need to make sure that your…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Replacement Coupler and Driver Side Arm for Roadmaster Stowmaster RM-501

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching