Timbren Rear Suspension Enhancement System Item # TGMRTTK30 Overall Height

Question

Question:

Of course this mounts under the frame but, What is the resting height from top to bottom of mounting purch and Timbren combined?

asked by: Samuel E

0

Expert Reply:

The overall height of the Timbren Rear Suspension Enhancement System # TGMRTTK30 is 7-1/8 inches.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Yes, there are spacers that can be used with the Timbren #TGMRTTK30 kit on your 1987 GMC Pickup with a 2-1/2" lift. We recommend using two of the 1" spacers #TA25723-90AD00 on each side. The idea is to have a 1/2" to…

view full answer...

Answer 2

Yes the Timbren Rear Suspension Enhancement System part #TGMRTTK30 is a confirmed fit for your 1994 C/K 3500. They have been designed as a bolt on upgrade and will help take alot of wear and tear off of your rear suspension system.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Timbren Rear Suspension Enhancement System Item # TGMRTTK30 Overall Height

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching