Which Roadmaster Rear Sway Bar Fits 2020 Jayco Alante 26X Built on Ford F-53 Chassis

Question

Question:

Hello, I just bought a 2020 Jayco Alante 26X, and I was wondering if this fits my RV? Roadmaster Rear Anti-Sway Bar Item # RM-1139-146 If it does, how difficult is it to install? Thank you in advance!

asked by: Mauricio J

1

Helpful Expert Reply:

Yes, the Roadmaster Sway Bar part # RM-1139-146 does fit your 2020 Jayco Alante 26x built on a Ford F-53 chassis with a 16k GVWR.

expert reply by: Jameson C

1

Answer 1

To soften road bumps in your 2011 Thor Hurricane Class A Motorhome I suggest an air bag kit. An air bag will do a better job than simple rubber jounce spring at absorbing road shocks before they can reach the Ford F-53 chassis on which the Hurricane…

view full answer...

Answer 2

That's a really good question. The issue that Ford has with the sway bars they install on their chassis is that since they do not install the body of the RV onto the chassis it's really hard for them to come up with a decent sway bar in their…

view full answer...

Answer 3

If you are referring to the Roadmaster Reflex Steering Stabilizer then the correct one for your 2019 Jayco Alante 26X is part #RM-RBK22-RSSA. If you are instead looking for a rear anti-sway bar we have this as well, the Roadmaster Rear Anti-Sway Bar…

view full answer...

Answer 4

The exact procedure could be a bit dependent on the exact model year of your Focus, but generally speaking you'll want the steering column locked, and the transmission in neutral. You should not need to disconnect the battery terminal. There…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 8

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Which Roadmaster Rear Sway Bar Fits 2020 Jayco Alante 26X Built on Ford F-53 Chassis

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching