Can MaxxAir Mini Deluxe Trailer Roof Vent be Powered by Wiring to Bathroom Light Switch

Question

Question:

Sorry not familiar with 12 volt Can i wire this to existing LIGHTSWITCH in bathroom? Or do i have to run wire to the coach battery?

asked by: Scott

1

Helpful Expert Reply:

The light switch in your bathroom should be connected to 12V power but I'm not sure that's where I'd connect the power for the MaxxAir Mini Deluxe Trailer Roof Vent w/ 12V Fan # MA00-03851. Reason being that if you wanted to leave the fan on but turn the light off then you wouldn't be able to do that. Since this vent fan has it's own on/off switch I'd try to locate another 12V power source or connect this to the light circuit before the switch so that your light and fan can be operated independently of each other.

expert reply by: Jon G

1

Answer 1

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Bruce, for a replacement Fan-Tastic brand RV roof vent I really like the part #FV803350 as it has a variable speed, reversible fan, a built in thermostat, power lid lift, and a rain sensor to auto close it in case it starts raining. The only…

view full answer...

Answer 4

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a…

view full answer...

Answer 5

It will indeed work; I just checked with Lippert for you and was able to verify the correct toggle switch for your Lippert Power Stance Electric Trailer Jack #LC69VR (which is the 813748), is the following: - Replacement Extend/Retract Switch for…

view full answer...

Answer 6

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 7

The MaxxAir Mini Deluxe Trailer Roof Vent part #MA00-03851 once installed will sit almost flush with the ceiling. The panel which houses the light and control knob I would say is around 1/4" - 1/2" thick so that is all that would…

view full answer...

Answer 8

With a few possible exceptions (large fifth wheels that use LT or Light Truck Tires), we recommended that only trailer tires be used on trailers because they have stiffer sidewalls which do a better job dealing with the vertical load tires…

view full answer...

Answer 9

The black top of the MaxxAir Mini Deluxe Trailer Roof Vent w/ 12V Fan #MA00-03851 is just under 4 inches tall so with the white base and black top combined, it will sit about 4-1/8 inches above the roof. I've attached a video to help with…

view full answer...

Answer 10

Although I would not be able to speak on the installation of the part(s) you received for your trailer, I can tell you that the TremPro 644 Silicone Sealant part #0160297 will do an excellent job of sealing your new aluminum panel to the trailer…

view full answer...

Answer 11

GM does not supply the attaching nuts required to secure the wires to the studs. These can be obtained locally. You will need (1) M6 x 1.0 nut, #185916 and (1) M8 x 1.25 nut, #185917. I have attached an FAQ for you that may also help.

view full answer...

Can MaxxAir Mini Deluxe Trailer Roof Vent be Powered by Wiring to Bathroom Light Switch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching