Can iPhone 6s be Used with Curt Echo Mobile Brake Controller

Question

Question:

We have a 2013 Grand Cherokee with a Kenwood 696S. Can my Apple 6S interface your controller with my car stereo?

asked by: Russell F

0

Expert Reply:

Yes, your iPhone 6s can be used to interface with the Curt Echo # C51180. The Echo requires iOS 8 or higher and your phone can support up to iOS 13 so that would not be an issue at all.

expert reply by: Jameson C

0

Answer 1

Yes, you can listen to music from your phone while using the Curt Echo Mobile Trailer Brake Controller #C51180. The app for the Curt Echo functions just like any other app on your phone so you can switch between apps while using your phone. Just be…

view full answer...

Answer 2

When it comes to The Curt Echo Brake Controller #C51180 if the Bluetooth gets disconnected or if you lose service, or if your phone battery dies, the last setting you had for the controller would be retained, but you will lose the ability to use…

view full answer...

Answer 3

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

view full answer...

Answer 4

The older versions of the Echo did not have the required bracket to install a strap. If you went with a newer version of the #C51180 you'd have improved connectivity as that was one of the other things they improved around time they added…

view full answer...

Answer 5

I spoke to Curt and the Echo Brake Controller #C51180 is not DOT approved. Unfortunately, they also mentioned none of their brake controllers are DOT approved and could not give me a reason as to why this is. With this in mind, I decided to contact…

view full answer...

Answer 6

We recently had a short training session in which the difference between our brakes such as #AKEBRK-10R and Dexter brakes were revealed. The biggest difference is the brake pad material. It is thicker on our house brand brakes. Also, on our brakes…

view full answer...

Answer 7

There are a few differences between the Universal Installation Kit part #ETBC7 and the 7-Way RV Upgrade Kit part #ETBC7L. The biggest one is that part #ETBC7 comes with both the power and brake output wire you will need to run to the cab/battery…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Can iPhone 6s be Used with Curt Echo Mobile Brake Controller

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching