Fit Kit for Thule Roof Rack on 2017 Chevy Colorado Crew Cab

Question

Question:

Rear does not fit 2017 Chevy Colorado Crew Cab using Thule kit Help. The rear crossbar is the only one I actually NEED to mount my kayak. What am I missing here? Need to go fishing!!!

asked by: Keith F

1

Helpful Expert Reply:

For your 2017 Chevy Colorado, if you have the Crew Cab Cab you need Crossbars # TH711420, Evo Feet # TH710501 and the Fit Kit # TH145179.

expert reply by: Jason S

1

click to enlarge

Steve B.

3/23/2024

My research shows 1783

Reply

Mike L.

4/10/2024

@SteveB The Thule # 1783 fit kit has been discontinued for quite some time, as has the Traverse roof rack feet it works with. The information Jason provided is correct.

Reply

Answer 1

The Thule #TH480R foot pack isn't compatible with the square crossbars unless they're the newer style that have the slots in the underside. Unfortunately, Thule no longer offers feet that are compatible with the older-style square bars nor is…

view full answer...

Answer 2

I have a solution for you, but the Yakima Q Clips are for the older Yakima roof racks and they are no longer available. You will want to go with a new roof rack system. For your 2020 Silverado 1500 crew cab with naked roof, I highly recommend going…

view full answer...

Answer 3

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

First you will need to add the Curt Trailer Hitch Receiver #C78VV to your 2024 GMC Canyon. Do note this will replace a factory crossmember that is used since your Canyon did not come with the factory tow package. Next the Hopkins Multi-Tow 7-Way…

view full answer...

Answer 6

There is no plug-in wiring adapter for a brake controller on a 2019 Chevy Colorado; most brake controllers such as the Prodigy P3 #90195 will need to be hardwired into the vehicle. For this you can use the Replacement Brake Control Plug-In Harness…

view full answer...

Answer 7

When flat towing a vehicle you do not want your steering wheel to lock as this would cause your tires to drag any time you try to turn while towing. Placing your 2022 Chevy Colorado's transmission in neutral and then placing the ignition into ACC…

view full answer...

Answer 8

The only set of airbag that are available for a 2019 Chevrolet Colorado with the diesel engine at this time are the Firestone Sport-Rite Air Helper Springs part #F2587. This system is a direct fit so no drilling is required. They have a 3,000 lb…

view full answer...

Answer 9

What you are seeing is correct, and you are right about the reasoning behind it. Since the key must stay in the ACCESSORY mode to keep the steering wheel from locking up, this means that there are some components that can drain your battery over the…

view full answer...

Answer 10

The main components needed to flat tow your 2019 Chevy Colorado are a tow bar, base plate, tow bar wiring kit, braking system, and safety cables. I have the following recommendations for you below: Tow Bar: Roadmaster Falcon All Terrain, Non-Binding…

view full answer...

Fit Kit for Thule Roof Rack on 2017 Chevy Colorado Crew Cab

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching