How to Pick Out Replacement Bearings for Cargo Mate Car Hauler

Question

Question:

I have a car hauler cargo-mate 20 foot. I dont know what bearings it has. I want to replace the bearings and seals. Which items do I need ?

asked by: Ken L

0

Expert Reply:

To pick out bearings for a trailer hub you will need to remove one of the hubs so that you can remove the bearings and get the numbers off of them.

Or, you can measure the spindle where the bearings and seal ride so that we can pick you out the correct bearings that would fit the spindle.

Check out the link I attached that has all the bearings we offer with their dimensions.

expert reply by: Jameson C

0

Answer 1

Usually a trailer axle will have a sticker or plate on it to indicate its weight rating. This may not be on the VIN sticker but it should be on at least one of your two axles. If not, contacting the manufacturer (Forest River, 574-264-4519) with the…

view full answer...

Answer 2

We currently have not had a Ford F-150 with the power outlet in the bed to test fit a bed mounted 7-Way #C57008. I see no reason you will not be able to still install the 7-way as there is a large gap which can be seen in the installation video which…

view full answer...

Answer 3

Since Valley went out of business there are no direct replacement parts that are available but a repair kit like the Curt #C25194 for 2" Curt Couplers may be compatible. What I recommend doing is replace your coupler completely as replacement…

view full answer...

Answer 4

The weight is 54 lbs for the Superwinch S7500 Trailer Winch #SW1475201.

view full answer...

Answer 5

The 07100 bearing number you referenced is an older bearing that has the same dimensions as #L44643. If both the inner and outer bearings on your existing trailer are the 07100/ #L44643, and the hub has a 4 on 4 inch bolt pattern, the correct…

view full answer...

Answer 6

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 7

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 8

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 9

When you use an over-under kit like the #K71-384-00 you will end up raising the trailer the thickness of the axles and leaf springs. I attached a picture that shows this. You will need to measure the thickness of your springs and axles to know how…

view full answer...