Replacement Electric A-Frame Trailer Jack for a 2008 Dutchmen T@B Travel Trailer

Question

Question:

I’m looking for electric A-frame jack to replace our jockey wheel on a Dutchman 2008 T@B camper. What do you recommend? I’ve been looking at Stromberg Carlson Electric Trailer Jack - Leg - A-Frame - 24 Lift - 3,500 lbs - Black Item # JET-3755.

asked by: William L

0

Expert Reply:

The Stromberg Carlson Electric Trailer Jack part # JET-3755 is an excellent option for a 2008 Dutchmen Tab Travel Trailer. It will be a direct bolt-on replacement with plenty of capacity to lift and lower the trailer. I really like the Stromberg Carlson trailer jack because it has a built-in bubble level in the head which helps with leveling the trailer and the drop-leg feature again just makes things much faster.

expert reply by: Conner L

0

Answer 1

We don't have a combo of the Curt Hitch Ball #C40008 and Curt Ball Mount #C45340. The ball mount is extremely heavy-duty, rated up to 17,000 pounds. I think it's safe to assume you don't have a torque wrench rated up to 450 foot pounds…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 8

For your Dometic DuoTherm the Advent Air Unit part #ACDOM150 would be your best option that will give you the higher BTU rating 15k and easily connects to the current wiring you have now.

view full answer...

Answer 9

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 10

Yes, you can! So long as our Kenda Loadstar 5.30-12 Bias Trailer Tire with 12" White Wheel item #AM30820 is the same size and bolt pattern as what's on your Ironton trailer it can be used not only as a spare but also on your trailer with the…

view full answer...

Replacement Electric A-Frame Trailer Jack for a 2008 Dutchmen T@B Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching