How Does RV Ladder # SP501L Attach to Roof

Question

Question:

How do the rails mount to the roof.

asked by: Rick A

0

Expert Reply:

I attached a picture that shows what the mounting brackets of the RV Ladder part # SP501L look like. These are what attach to the roof of your RV.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I attached a picture that shows what the mounting brackets of the RV Ladder part #SP501L look like. Outside to outside of the rails on the RV ladder part #SP501L measures 13 inches. Typically bolts and nuts are used to hold the aluminum flanges…

view full answer...

Answer 2

I spoke to my contact at Surco and she informed me that from the very top to the very bottom the Surco Ladder part #SP501L measures 97 inches. The distance from the portion that attaches to the roof of the RV to the ladder is 17 inches.

view full answer...

Answer 3

The Surco Universal Exterior RV Ladder with Center Hinges for Contoured Rear Wall, #SP501L, will work when mounted to a bumper depending of course on the bumper position. This probably isn't the best case scenario as it would be better for a…

view full answer...

Answer 4

The hinges of the Surco RV Ladder part #SP501L that you referenced will allow the ladder to fold up a little past 90 degrees if needed. Normally they don't end up folding that far since they are designed to fit the contour of the rear of an RV,…

view full answer...

Answer 5

From the surface of the RV the ladder part #SP501L installs on out to the ladder measures 5 inches.

view full answer...

Answer 6

I do have an option for you but we do not carry OEM ladders. Instead, I recommend using the Surco Universal Exterior RV Ladder part #SP501L which is a universal ladder as the title states and works on a variety of RV's. The ladder has a hinge for…

view full answer...

Answer 7

The total width of the #SP501L ladder is 12-3/4 inches. This is the outside measurement of the step pads since that's the widest point. The actual dimension of the step that's usable for your foot to land is about 10 inches between the…

view full answer...

Answer 8

It actually looks like the ladder you currently have is exactly what you're already looking for - you just need to remove the screws from those bottom supports and then you can flip the ladder up since it's hinged higher up. If that isn't…

view full answer...

Answer 9

Yes, you can use the 1156 LED Bulbs - 360 Degree - Single Contact Bayonet - 1,000 Lumens #ARC28FR as an interior dome light and it will not put out any more heat than a standard incandescent light bulb. This is designed for in-vehicle use.

view full answer...

Answer 10

The Lippert Kwikee 39 Series #LC3724742 and 28 Series #LC3747453 single steps are pretty similar with just a few dimensional differences. Here are the dimensions: Kwikee 39 Series Entry height: 11" Step dimensions: 23-3/4" wide x…

view full answer...

Answer 11

The bolts on your Advent Air RV Air Conditioner w/ Air Distribution Box and Start Capacitor - 13,500 Btu - White Item #ACM135C are supposed to be torqued to about 33 to 35 in/lbs. It sounds to me like your wrench might be set to ft/lbs and that's…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

How Does RV Ladder # SP501L Attach to Roof

Product Page this Question was Asked From

Continue Researching